2004 Ford Freestar back or rear turn signal light bulb lamp replacement procedure: Purchase the correct replacement turn signal light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the turn signal light bulb lamp replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
T-40 bit!
REPLACE THE BULB
the blinker switch shorted out the brake lights... really really common problem, need to replace the switch
the bulb for brake and signal lights has two elements. in your case the element for brakes is open and you will have to replace bulb.
you DO NOT disassemble the lens cover!!!! Open the hatch, and you will see small access panels directly behind the taillights that open. Just open the panel and take the bulb out.
Turn signal switch is melting...replace the turn signal switch in the steering column.
You have to go inside the trunk and remove the circular plastic covers from behind the lights. Then you have to unscrew the entire light and you can access the bulbs to replace them.
If you look at the cover on the brake fluid reservoir, it should read DOT 3
blinker switch is part of that system is most likey problem trust me i owned 9 s10 all 82-94 and college for 5 years of elec/auto replace the blinker switch on the clolume"
Remove wheel and brake drum, disassemble brake parts, disconnect brake line from back side, remove 2 bolts holding cylinder on from backside of brake plate, install new one, tighten bolts, attach brake line, reassemble brake, reattach wheel, and bleed brakes.
How to brake down a hawthorn 880 22
The tail lights are on a separate wiring than the blinker/brake lights. Look for a blown fuse or a broken/loose wire.