answersLogoWhite
Seat Belts and Safety Systems
Mercury Villager
1995-2005 Chevy Cavaliers

How do you disconnect the motor for the drivers side automatic seat belt on a 1995 Mercury Villager as it will not shut off nor move the seat belt?

212223

Top Answer
User Avatar
Wiki User
2006-07-19 22:20:15
2006-07-19 22:20:15

i don't have an answer, but am wondering if you have found the answer. Answer remove the plastic cover ob the piller B. And disconnect the connection for seatbelt motor

1

Related Questions

User Avatar

On a Mercury Villager ( being a front wheel drive vehicle ) The transaxle ( transmission ) is located in the engine compartment to the drivers side of the engine

User Avatar

On a 1997 Mercury Villager open the drivers door and on the latch pillar you will see an information sticker that shows the original size tires on the vehicle from the factory

User Avatar

At the top of the drivers side kick panel.

User Avatar

The 1995 Mercury Villager turn signal relay switch is located beneath the drivers side dashboard. The turn signal relay switch will be left of the brake pedal.

User Avatar

If you mean the reset button on top of the FUEL PUMP SHUT OFF SWITCH the switch is located in the drivers footwell , behind the kick panel , by your left foot ( there is an access hole ) on a 2000 Mercury Villager

User Avatar

if it is equipped from factory it is mounted by the rear controls for the radio behind drivers seat

User Avatar

The fuel filter is located under the hood on the drivers side beneath the master cylinder

User Avatar

hidden back drivers side storage compartment, passengerside should have your Jack etc.

User Avatar

If it is electric it's switch is on the drivers door next to the switches for the front windows

User Avatar

It's the interior trim panel , just in front of the drivers door

User Avatar

According to the 2001 Mercury Villager Owner Guide : The fuel pump shut off switch ( inertia switch ) is in the drivers foot well , behind the kick panel ( there is an access hole ) * from the drawing it is near the inside hood release

User Avatar

If you're talking about the headlight, the "lens cover" is not a separate part, you need to replace the whole headlight assembly.

User Avatar

In the drivers footwell , behind the kick panel . There is an opening in the kick panel to access the red reset button on top of the switch

User Avatar

On a 2000 Mercury Sable : The automatic transaxle ( transmission ) fluid level dipstick would be near the firewall just to the drivers side of the engine ( where the transaxle is bolted to the engine )

User Avatar

http://computertasks.blogspot.in/2009/10/mercury-pi865d7-drivers-free-download.html

User Avatar

The mountaineer has a fuse box under the drivers side dash ,and it has two horn fuses , right horn fuse ,and left horn fuse.

User Avatar

If it is equipped with a transaxle dipstick it will be on the drivers side of the engine compartment - near the brake fluid reservoir

User Avatar

As long as the headlight are turned off, you do not have to disconnect the battery.

User Avatar

The drivers side kick panel is in the drivers footwell , just ahead of the drivers door It is an interior trim panel by the drivers left foot

User Avatar

The Automatic transmission breather tube is on the drivers side of the vehicle and is under the air filter box under the hood, it often reaches up near the battery tray.

User Avatar

Disconnect the battery, which you should do anyway when replacing an ignition. There will then be no danger of it inflating.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.