Car Horns
Ford Explorer
Ford Explorer Eddie Bauer
Ford Explorer XLT

How do you disengage the horn or alarm system on a 1993 Ford Explorer?

888990

Top Answer
User Avatar
Wiki User
2015-07-15 21:15:20
2015-07-15 21:15:20

The alarm brain is located in the rear of the SUV, in the jack compartment. You can disable it temporarily by removing the horn fuse, or by unplugging the harness from the brain. Unfortunatly the latter will cut your interior lights, but at least your horn won't sound off everytime you shut off your truck.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The 1993 Ford Ranger does not have an alarm override but. You can override the alarm system by removing the alarm system fuse.

User Avatar

The alarm switch system is not working right. This could be a door switch, or a wiring problem. the system needs to be checked one switch at a time, then the wiring is checked next.

User Avatar

your brake system is a good one because you have to push the brake to disengage it, as if it was on a spring.

User Avatar

How do you disable the Anti-Theft light in the 1993 ford explorer

User Avatar

On a 1993 Ford Explorer : None , unless it has been converted from R12

User Avatar

The easiest way to disable your 1993 Buick factory alarm is to remove the alarm fuse. The alarm fuse can be found in the fuse box.

User Avatar

The easiest way to bypass the 1993 Buick factory alarm is to remove the factory alarm fuse. The factory alarm fuse can be found in the fuse box.

User Avatar

A 1993 Ford Explorer has shock absorbers , front and rear

User Avatar

The Northwest Explorer was created in 1993.

User Avatar

Wake the owner up and kindly ask him to disarm the alarm in order for you to steal it without waking up the neighborhood. ANSWER press the panic button on your key fob , if the alarm is honking and lights are flashing , it will shut off , or unlock the Explorer . (Helpfull)

User Avatar

If you are on WikiAnswers trying to learn how to steal a car, I would suggest against it.

User Avatar

Your alarm system is to blame for this issue, try disconnecting your alarm from the fuse box and try starting the car again.

User Avatar

Remove the alarm, i did the same in my altima,the alarm box is located under the dash by the steering column, is a little black box, disconnect the terminal and you will be ok.

User Avatar

haynes repair manual for 1993 Ford Explorer Eddie Bauer

User Avatar

I believe the 1993 Ford Explorer ( 4 door ) is 19.3 U.S. gallons

User Avatar

I believe on the 1993 / 1994 Ford Explorer it is mounted low on the firewall near the drivers side fender

User Avatar

The 1993 Ford Explorer is designed to use " regular " unleaded , 87 octane

User Avatar

According to my Haynes Ford Explorer repair manual : ( MERCON automatic transmission fluid is used in the transfer case of a 1993 Ford Explorer )

User Avatar

on my 1993 jeep GCL i removed fuse 6 and 7 from the fuse box to disable my alarm i hope this helps

User Avatar

Turn off alarm with ignition key in the driver's door.

User Avatar

A 1993 Ford Explorer takes 5 quarts of oil for a complete oil and filter change.

User Avatar

How would i repair a 1993 ford explorer 4.0 liter A4LD Transmission?

User Avatar

On a 1993 Ford Explorer ( 4 door) I believe it is 19.3 U.S. gallons (Helpfull)

User Avatar

Where is the fuse located that controls the inside dash lights on a 1993 Ford Explorer

User Avatar

Your EEC test port is in the engine compartment by your power distribution box EEC IV / OBD I system


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.