bbc
I think you mean a common emitter amplifier, which is an amplifier of voltage. Emitter-follower or common collector amplifiers are used to match impedances, or to amplify power or current. The emitter-follower is a type of common emitter circuit that has a resistor between the emitter and ground. The output signal is taken from the point between the emitter and its resistor.
You can use an npn or a pnp bjt in a common emitter amplifier circuit. The decision of which one to use is based on whether you want the collector and base to be more positive (npn) or more negative (pnp) than the emitter.
An emitter resistor in a common emitter circuit will cause the stage to experience the effects of degenerative feedback if it is unbypassed. The degenerative feedback reduces gain. This is probably the primary effect in the described circuit.
With a common emitter amplifier it's the emitter that is usually grounded.
No the base emitter circuit is not the same as a common base circuit. The three BJT circuits all have the base emitter circuit. Wheter each terminal is common to both inputs and outputs of the circuit determines the type of transistor configuration.Henry Lee Everson PE;229-560-9769
The gain of a common-emitter amplifier is collector resistor divided by emitter resistor, or hFe, whichever is less. Since hFe depends on temperature, designing the amplifier to be dependent on resistance ratio makes it more stable. As such, the emitter resistance serves to stabilize the amplifier.
A: REFERS TO A common emitter amplifier
A capacitor has lower resistance (impedance) as frequency increases. Adding an emitter capacitor effectively lowers the emitter resistance as frequency increases. Since gain in a typical common emitter amplifier is collector resitance divided by emitter resistance, this decrease in emitter resistance will increase gain as frequency increases.
what is the other name of common emitter amplifier
In electronics, a common-emitter amplifier is one of three basic single-stage bipolar-junction-transistor (BJT) amplifier topologies, typically used as a voltage amplifier. In this circuit the base terminal of the transistor serves as the input, the collector is the output, and the emitter is common to both (for example, it may be tied to ground reference or a power supply rail), hence its name.
it is a circuit consisting of a tuned circuit with a capacitor in parallel with inductor and it is connected to collector terminal in common emitter configuration,, and it is used as frequency receiver
A swamped amplifier has a resistance tied to the emitter of the NPN transistor. Swamping the amplifier reduces the voltage gain. When an amplifier is swamped the voltage gain to the output is less dependent on the load. This helps to balance the output and protect the circuit when different loads might be applied.