The crankshaft has four 8mm bolts that hold the pulley onto the camdrive pulley.Do not remove the large bolt in the center unless you are going to replace the crankshaft seal.Also be sure to tighten that bolt if removed, it will walk back and forth and damage the crank eventually.
What tools do you need to remove the crankshaft pulley on a 1995 Honda Passport?
Depending on engine displacement in general remove belt-s then bolt holding pulley to the crankshaft then using a puller remove the pulley, when installing use a installer not a hammer to put the pulley on the crankshaft.
u need to buy new pulley then, remove serpentine belt from engine remove bolts that hold pulley to crankshaft remove pully instalation is exact opposite of removalAnsweru need to buy new pulley then, remove serpentine belt from engine remove bolts that hold pulley to crankshaft remove pully instalation is exact opposite of removal Answeru need to buy new pulley then, remove serpentine belt from engine remove bolts that hold pulley to crankshaft remove pully instalation is exact opposite of removal
The crankshaft pulley unbolts from the harmonic balancer. The harmonic balancer can be removed from the crankshaft with a 3 bolt puller.
Hello! The crankshaft position sensor is located behind the crankshaft pulley,on the left side facing the front of the car.It is difficult to see and to remove it you need to remove the crankshaft pulley ( radiator,belts,.... )
Remove crankshaft pulley& ballance
Disconnect the battery and remove the fan assembly and crankshaft belts. Remove the center bolt from the pulley and use a crankshaft pulley remover to pull off the pulley. You can usually borrow one from an auto parts store.
1998 Nissan pathfinder crankshaft pulley bolt is right handed.
Depends on what type of vibration damper (crankshaft pulley) you have. Your local auto parts store probably has the one you need and can rent it to you.
Remove bolt, and use a harmonic puller to remove pulley.
Your will have to loosen up the alternator, and take off the alternator belt from around the crankshaft pulley. To get the crankshaft pulley bolt off, you will have to use in impact wrench on it. Should be on the driver side of the car. Also it is a regular threaded bolt. The torque on it from the factory is around 115lb/ft. You will need a 17mm Impact socket and a good impact wrench. It will not break loose easily if there is rust on it like most that are 20 years old. Even with penetrating oil it will not be an easy job. Use care when working with the crankshaft pulley as it is old and will crack easily as well.
no