Want this question answered?
whenever you log into your cisco router....
User enable. router> enable router#
On a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routingOn a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routingOn a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routingOn a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routing
Router#banner motd @ MESSAGE @ Like this the syntax should u must start and end with a unique character (any)
Router#banner motd @ MESSAGE @ Like this the syntax should u must start and end with a unique character (any)
You can do this on the enable, or privileged, prompt.
I'll go to hellis Cisco in a Cisco router. What would the prompt look like for global configuration
The "enable" command will bring the privilege level from user exec to privileged exec. Example: R1> R1>enable R1#
On a cisco router you would go into privilege-exec mode (enable) and then into "configure terminal" mode. From there you can use the router rip command.
router>enable router#configure terminal router(config)#line vty 0 4 router(config-line)#password cisco router(config-line)#login to configure router with telnet you must set up password or secret for privilieged mode.
Some recommended books about Cisco routers are: Cisco Router Configuration, Cisco Routers For The Desperate, Cisco Routers for IP Router, Cisco CCNA Routing and Switching.
On user exec mode type enable. When inside the privilege mode type configure terminal. You will then be sitting into global config after this. Please see below example: Router>enable Router#configure terminal Enter configuration commands, one per line. End with CNTL/Z. Router(config)#