answersLogoWhite

0

You can do this on the enable, or privileged, prompt.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

What is global router configuration?

I'll go to hellis Cisco in a Cisco router. What would the prompt look like for global configuration


What router prompt can you use the router rip command?

On a cisco router you would go into privilege-exec mode (enable) and then into "configure terminal" mode. From there you can use the router rip command.


Which option would be a valid router hostname according to Cisco naming convention guidelines?

Which option would be a valid router hostname according to Cisco naming convention guidelines? Rtr1_Bldg201 Building_201 Router 1 1st_Floor_Router_409_West_State_Street


What prompt can you issue show commands to investigate a Cisco Router?

User enable. router> enable router#


What mode must be in to configure IP address on a Cisco router?

interface mode


How can the hostname can be removed in cisco?

With the following command: No hostname


Which command sequence will permit access to five router virtual terminal lines with a password of cisco?

router>enable router#configure terminal router(config)#line vty 0 4 router(config-line)#password cisco router(config-line)#login to configure router with telnet you must set up password or secret for privilieged mode.


How do you connect a router to cisco 1800?

To connect to a cisco 1800 series router, you need either a network connection that goes to the router, and then you would configure the router to allow telnet or you would need a console cable, also called a rollover or cisco cable and physical access to the device.


What are the hyper terminal settings to allow configure a cisco router?

9600 8-N-1


How can configure isdn in cisco router?

Changing the username and password that a Cisco ISDN router uses to dial-up ... in the router configuration in encrypted format, so even if you canview the settings. By lutaaya sulaiman +256753302061; lutasula@yahoo.com


What is setup mode?

When a Cisco router is booted up for the first time, or is reloaded, the router will look into its Non-Volatile RAM (NVRAM) for the startup configuration file. Setup Mode is usedto configure a Cisco router or switch after start up to create a startup configuration file.


You've just received a new Cisco router for your data center and it came with a roll over cable What can you do with this cable?

make a connection from the router's console port to your laptop's serial port and configure the router from your laptop.