answersLogoWhite

0

The "enable" command will bring the privilege level from user exec to privileged exec.

Example:

R1>

R1>enable

R1#

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you enable ip routing to yes?

On a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routingOn a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routingOn a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routingOn a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routing


What router prompt can you use the router rip command?

On a cisco router you would go into privilege-exec mode (enable) and then into "configure terminal" mode. From there you can use the router rip command.


What prompt can you issue show commands to investigate a Cisco Router?

User enable. router> enable router#


Which command sequence will permit access to five router virtual terminal lines with a password of cisco?

router>enable router#configure terminal router(config)#line vty 0 4 router(config-line)#password cisco router(config-line)#login to configure router with telnet you must set up password or secret for privilieged mode.


What is the command line interface used for a Cisco router?

Cisco IOS uses a command line interface (CLI) for inputting commands when configuring Cisco Routers


What is the command line interface used for on a cisco router?

Cisco IOS uses a command line interface (CLI) for inputting commands when configuring Cisco Routers


How do you remove a static route from a routing table?

Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....


What is the command on a Cisco router that will display all the routes the router knows?

show ip route


At Which Prompt would you configure the Hostname on a Cisco Router?

You can do this on the enable, or privileged, prompt.


How do you see how much ram is on a cisco router?

The "show version" command.


What command enables a DHCP relay on a Cisco router?

hal-loosi


What password would be set by issuing the following command enable secret password cisco?

Cisco