You have to open a notepad and type "command.com" without quotes. Save it wherever you want to be able to open it from as "command.bat" without quotes.
enable after the Router> prompt
To enable assembly binding log, open the Visual Studio Command Prompt and type fuslogvw.
Command prompt: iscsicli FirewallExemptiSNSServer
Use "prompt $p$g" command.
Safe mode with command prompt option is totally depends on DOS shell, hence there is no need for separate command prompt..
On a cisco router you would go into privilege-exec mode (enable) and then into "configure terminal" mode. From there you can use the router rip command.
when using command prompt, after you give it a command, press the enter button. Command prompt will then carry out the task and will automatically go to the next line.
PROMPT command is an internal command, which is used to change the MS-DOS prompt. Through, the system displays the prompt bu default, when you start the computer.
In command prompt write "ipconfig/all" command and then press [enter]. And see the IPv4 Address section in the commend prompt.
when you are in cmd command prompt "type" help and you will see all the codes
As Admin In Command prompt, type: netsh firewall set icmpsetting 8 enable Enter
open notepad (right click new word doc) type in this @echo off command comand.com pause save this as somthing.bat the .bat is importaint now save this to your desk top at school and click on it that will open CMD