Both washers use the same reservoir under the hood. You open the hood and pour it in.
You add the fluid down the dipstick tube.
Open the rear liftgate , above the left taillight lense you will see a rubber cap/plug , that is your fill point - I like to remove the plastic cover panel in the drivers rear of the cargo area so I can see the level of the washer fluid in the container
On level ground, fill it to the bottom of the hole.
It is the same reservoir as the front, under the hood.
The brake fluid reservoir in a 1991 Jeep Cherokee is located on the master cylinder. To add fluid, unscrew the cap and fill to the appropriate level with the appropriate brake fluid, more than likely dot 3.
Both washer systems are fed from the same reservoir under the hood.
Both washer systems are fed from the same reservoir under the hood.
Fluid is added down the dipstick tube.
where to fill washer fluid back window 2012 kia sedona
You fill the reservoir under the hood.
Same place as you fill the front washer fluid. There is only one reservoir.
The rear window wiper uses the same fluid reservoir as the front, it just has a separate rear window pump attached to the fluid bottle under the hood.
A 1997 Jeep Wrangler TJ manual transmission engine can be filled with 6 quarts of fluid. Its cooling system, on the other hand, can be filled with 11 quarts fluid.
No. Automatic transmission fluid is the recommended fill.
Should be a plug on the side of the transmission - fill to this level
if it has a fluid view window, fill to cover window. if not, fill near top of fill hole. It cant hurt a thing having it full.
I believe that the front and rear window fluid are in the same place