It depends on the operating system you are using. Most windows systems use the 'ipconfig' command to look at the network adaptor configuration, whereas Unix/Linux use the 'ifconfig' command.
Formerly know as the Network Administration Tool in RedHat, which was known as System-Config-Network due to it's command line invocation. Newer releases of RedHat uses the NetworkManager instead of Network Administration Tool.
Remove Console password router>enable router#configure terminal router(config)#line console 0 router(config-line)#no login router(config-line)#no password router(config-line)#exit router(config)#exit
RTRA(config)# line vty 0 4 RTRA(config-line)# login RTRA(config-line)# password cisco
router(config)#line vty 0 4router(config-line)#transport input ssh
Ubuntu: system-config-printer brings up a GUI printer configuration
Router(config)# line vty 0 4
A(config)# router rip A(config-router)# passive-interface S0/0 B(config)# router rip B(config-router)# network 192.168.25.48 B(config-router)# network 192.168.25.64 A(config)# router rip A(config-router)# no network 192.168.25.32 B(config)# router rip B(config-router)# passive-interface S0/0 A(config)# no router rip
The command for launching the graphical package management tool in some Linux distributions is system-config-packages. However, this tool may not be installed by default and might not be available on all distributions. If you need to manage packages via the command line, consider using package managers like apt, yum, or dnf, depending on your distribution. To check if system-config-packages is installed, you can run which system-config-packages in the terminal.
router>enable router#configure terminal router(config)#line vty 0 4 router(config-line)#password cisco router(config-line)#login to configure router with telnet you must set up password or secret for privilieged mode.
Type on previllage Mode:- Router(config)#line vty 0 4 Router(config-line)#pass Router(config-line)#password 123 Router(config-line)#login Router(config-line)#exit used for telnet , to take ur PC on telnet through Router..............
You don't want to allow adjacent devices to gain information about this router for security reasons.SolutionYou can disable CDP on a single interface by using the command no cdp enable interface configuration command: Router1#configure terminal Enter configuration commands, one per line. End with CNTL/Z. Router1(config)#cdp runRouter1(config)#interface FastEthernet0/0 Router1(config-if)#no cdp enableRouter1(config-if)#end Router1#And you can disable all CDP on the router with the global configuration command, no cdp run: Router1#configure terminal Enter configuration commands, one per line. End with CNTL/Z. Router1(config)#no cdp runRouter1(config)#end Router1#
PING command verifies the existence of a node on a network. Ping command is a command of command line interface . It is used to check if the host is alive or not.