0
Add your answer:
Earn +20 pts
How do you read codes on Tacoma?
Get a obd2 scanner code reader,plug it into the ALDL connector under the dash and navigate through until you find what you need.
Where can one find a car code reader online?
You can find a car code reader on various websites like FamilyHandyman and Amazon. Both websites offer a great variety of products, including a car code reader.
Where is the dignostic eec-iv connector on ford E150 van located to hook code reader to?
you can find it on the inside of the passenger side fender by the battery under a usually black cover labeled as such
How do you read a odb code on a 2000 z24 cavalier?
Use a code reader, scanner or jumper the OBD2 connector terminals. (Connector located under lower edge of dash at steering column). You will need a pin chart and then retreve the codes manually. Best to get the manual of find someone who has access to a shop repair manual.
Find computer codes for 2003 Oldsmobile alero?
Plug in a portable code reader. It will display the trouble code, then you find it in the book provided with the code reader. That code will tell you the area that is causing the light to come on.
Where is the obd-1 or obd-2 connector on your 1993 mercury villager what pins do you connect to find stored codes?
1993 is OBD I and the connector is in the engine compartment above the transmission on the driver's side. I suggest using a code reader rather than trying to short wires.
Where can you find the horn fuse on a 1993 Ford E250 Van?
where do you find horn fuse on 1993 e250 ford van
How do you delete a code on a 2006 corvette with out a code reader?
find a autozone they scan and reset codes for free
What would cause a 1998 Buick Regal GS to shut off after running for ten seconds?
Check MAF sensor and connector plug at the air cleaner, and fuel pump and relay, if you can get someone there to put a code reader on it you can find out exactly what it is.
Where is the code reader ona 1994 ford explorer?
You will find it mounted to bottom of dash pannel above center hump in floor, well that's the connection for the code reader. the actual reader is something you have to use to retrieve the error codes.
Where can you find a diagram to correct the wires from the distributor to the plugs in 95 ford e250?
where can you find a diagram to correct the wires from the distributor to the spark plugs on 95 ford e250?
Why is Jaguar XKR engine light on?
Could be almost anything to find out you need a code reader to plug into cars comp and retrieve the code.
