0
It should be some where on your intake manifold with one or two wires running to it.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What could cause the temp light to come on when the temp gage says 198 degrees and the fan works properly on a 1997 VW Golf GTi?
have you checked your coolant temparature sensor
Where is the ECT sensor located in a 2002 GTI?
G2 Engine Coolant Temperature (ECT) SensorG2 Engine Coolant Temperature (ECT) SensorG32 Engine Coolant Level (ECL) SensorG32 Engine Coolant Level (ECL) SensorG32 Engine Coolant Level (ECL) Sensor
Where is the temperature sensor on peugeot 206 gti?
The temperature sensor of 206-gti is in the bottom of the right case of mirror.
Coolant used for a 206 gti?
The coolant used for a 206 GTI is a mixture. This mixture is Glysantin 33 anti-freeze and corrosion inhibitors mixed with an equal amount of water.
Where is the iat sensor on a Peugeot 206?
Peugeot have two types of IAT sensors. This first sensor for IAT is combined with the MAP sensor. The second IAT sensor for the GTi & GTi 180's are separate entitties and are located at the top of the throttle body.
Where is the speed sensor located on a 1995 golf gti?
speed sensor is behind starter motor
Heater not working in 106 gti all you hear is a gurgling noise?
Your coolant is low.
Where is the knock sensor on mk4 golf?
on My 2002 gti it is under the intake manifold.
How do you change a camshaft sensor on golf gti mark 3?
The camshaft sensor is located in the distributor. I believe you have to replace the hole distributor.
Where is the camshaft position sensor on mk3 golf gti 95?
I'm sure its in the distributor.
Where is a crankshaft position sensor on a vw golf mk2 gti 16v?
There isnt one.
Replaced thermostat in your golf gti 1991 but still no heat why?
You must make sure that you have purged all air from the coolant system. An air bubble will not allow proper flow of coolant and could also cause the engine to overheat. Add coolant into resevior and leave top off with engine running. Add more coolant as required. If temp gets too high with cap off and coolant starts to back out of resevior, then replace cap and allow to cool. Remove cap after cool and top up coolant again and repeat procedure.
