answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you find the joist in a wall?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is a wall to wall supporting beam called?

joist


What are the ends of the joist nailed too?

Floor joist or ceiling joist? Floor joist have a board on the end all the way along the side of the building called a rim joist. Like the cross bar on the top of a T. Ceiling joist are nailed down into the top plate of the wall and to the rafters where possible.


What is a band joist?

it is the board that is put on the top of the basement wall and then the side wall is built above that.adding foam to this joist helps to reduce air infiltration up to 25 percent.


Beams transfer loads from the joist to the?

beam transfer loads from the joist to the wall or column where it supports..


Typically joist are connected to wood beam using?

Nails. If they cannot be placed on top of a wall or beam a joist hanger is required as well.


Where can you find a floor joist span table when using 2 x 6 tongue and groove?

Not sure what you mean? floor joist span table???


How to run wire through joist?

Drill a hole large enough and pull the cable through. The hole must be 1-1/2" from the edge of the joist to prevent nails or drywall screws from penetrating the cable. If the hole is less than this distance, a nail plate must be installed over the edge of the joist so when the wall covering is added, a screw or nail can't penetrate the wire. Any hole drilled through a joist must be no more than a fifth of the depth of the joist and should be as near as possible to the centre of the joist. Holes bigger than 30mm are not recommended without specifically designed additional strengthening to the joist.


Is it safe to put something weighing 1000 lbs on an inside wall?

that would all depend on what is under that wall. If it is running along a floor joist that is properly supported, then I would do it


What is softwood made up of?

Do you mean what can soft wood be used for. Here are some uses. Roof trusses/ floor joist/ ceiling joist/ stud partitions/ timber flooring/ wall strapping/ linning boards internal finnishing. ect


How to shim a joist on a load bearing wall?

If a shim is required that means there is a gap somewhere. Cut a piece of wood which fill the gap. Nail it in.


What can be a word sentence of joist?

A joist is a beam, a supporting structure in a building. The roof joist was riddled with dry rot and had to be replaced.


How much weight can you put on a floor joist?

it depen on the size of the joist