answersLogoWhite

0

How to run wire through joist?

Updated: 9/15/2023
User Avatar

Wiki User

14y ago

Best Answer

Drill a hole large enough and pull the cable through. The hole must be 1-1/2" from the edge of the joist to prevent nails or drywall screws from penetrating the cable. If the hole is less than this distance, a nail plate must be installed over the edge of the joist so when the wall covering is added, a screw or nail can't penetrate the wire. Any hole drilled through a joist must be no more than a fifth of the depth of the joist and should be as near as possible to the centre of the joist. Holes bigger than 30mm are not recommended without specifically designed additional strengthening to the joist.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How to run wire through joist?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What happens where cables have to pass through a wooden joist?

Nothing happens. A hole is drilled through the joist and the wire is pulled through it.


How many watts can run through wire?

1,200


What was the Berlin Wall before it was a wall?

It was a barrier of barbed wire. When people began to run through the wire, they built it into a wall.


Is electricity faster in a thick or thin wire?

They run through both evenly! .o.


Is electricity faster in a thick wire or thin one?

They run through both evenly! .o.


What are the ends of the joist nailed too?

Floor joist or ceiling joist? Floor joist have a board on the end all the way along the side of the building called a rim joist. Like the cross bar on the top of a T. Ceiling joist are nailed down into the top plate of the wall and to the rafters where possible.


How can a coil of wire pick up a nail?

When a wire has an electric current run through it it produces a magnetic feild. A coil of wire (also called a selonoid) produces a strong magnetic feild perpindicular to the turns of wire when a current is run through it. This is also known as electric magnet. Its also worthy to note that speakers work based off of this concept


What can be a word sentence of joist?

A joist is a beam, a supporting structure in a building. The roof joist was riddled with dry rot and had to be replaced.


Where can you run a 4 AWG power wire through the firewall in a 2007 RAV4 for an amplifier setup?

Run the wire under the car and come up under a seat (front or rear) or where it's convenient.


What is the meaning of the word solenoids?

A solenoid is a complex electrical component. It is a cylinder with wire wrapped around it that acts as a magnet when electricity is run through the wire.


How much weight can you put on a floor joist?

it depen on the size of the joist


How do you run a power wire on a 2005 Pontiac sunfire for subs through the fire wall with out drilling is there any plugs in the fire wall or do you have to drill?

YOu can easily run your wire from your battery, to just underneith your brake booster on your fire wall. There is a Bundle of wires going through the grommet in the firewall, going into the driverside wall. Then you pull up your floor trim on the driver side, and lay the wire where ever it will fit. Run it to the back of the rear seat, if you have one, and there you go. there is a rubber grommet under the brake booster. to access a wire to go through insert needle nose pliers through catch the wire ,hold, and pull