Want this question answered?
how to fit glow plugs scoda octiva
If you're a tool! Vw parts in Skoda much better than Toyota It would fit in the back of my octavia estate no problem. would be only to happy to run it to the scrapyard for you.
Depends on whether you pinched some bmw wheels to fit them.
the middle wire on the speedo block on the engine by the gear lever in the engine
Depends on the registration. For a 2008+ Octavia, the fusebox is located to the side of the driving console. Open the driver's door and it's located on the side. There's a small notch near the bottom of the cover, which can be carefully removed with a flathead screwdriver. It's a bit of a pain to fit back again - just slide the panel back, making sure the relevant catches are lined up with the holes. I'm not a mechanic or anything, just an Octavia owner.
my neighbour pulled the u clip off door lock barrel and does not know how to put the clip back on 1996 Hyundai excel sprint
13cm
You will need a slide/ barrel bushing that will fit the barrel you want to install.
A PMI razzor barrel (spyder thread) will fit your barrel needs. You know it will fit if it is "spyder" threaded.
Barrels are to small to fit any one horse into it. So no horses can fit into a barrel.
On the INSIDE of the door there is a triangular panel where the wing mirror is, on my one there is a small speaker attached to the panel. Pop off the panel with a screwdriver and there is a block connector in the hole, attached to the door, you should be able to pull this up enough to disconnect the wires, if not you'll have to take off the door panel to get at the connector. There is 2 bolts where the triangular panel was and 1 bolt in near the hing of the door, open these and the wing mirror comes away form the door. There is a piece of sponge in the hole where the wires go through, push the block connector through this and the mirror is free. Hint: If you have a magnet put it on to the spanner you're using to take off the bolts, it will stop them from falling down inside the door panel.
Yes, the 98 threaded Flatline Barrel will fit the Alpha black.