Remove the lower left-side fairing panel, exposing the sprocket cover and the speedo drive/ differential. Turn the wheel to the right, allowing access to the underside of the speedo. The job can be done with the bike on it's side-stand if preferred.Remove the two Allen bolts at the top and bottom of the diff and carefully pull this out and away. Undo and remove the Philips screw that holds the cable outer in and pull the two apart.Go to the other end, feeling your way up the cable outer until you locate the rounded end-nut under the speedo. Undo this carefully, using large pliers if necessary. If you can get to this using this method, it saves having to remove the screen, upper panel and clocks. Before installing the new cable, separate the inner from the outer and lube up with General-Purpose Grease, wiping away any excess.Once free, the whole old cable can be pulled out in the direction of the front of the bike.There may be a couple of cable-ties that need to be cut and don't forget to tie the end of the new cable loosely to the old to allow it to follow the same path. This goes up and over the radiator and through the fairing bracket but is easy enough to follow. Do not force or pull, before investigating any potential snagging. After you have fed the cable through, connect at the speedo and tighten. The diff needs to be connected to the bottom end of the cable, but before doing this, ensure that any old grease is cleaned out and replaced with new. Push onto the cable and replace the Philips screw. Relocate the diff into the drive socket behind the sprocket cover and replace and tighten the two Allen bolts. Secure the cable to the frame spar with a couple of cable-ties and replace the fairing panel, checking for snags. I hope this is helpful.Dave C.
Will the exhaust pipes for a Honda shadow 1100vt fit a Honda shadow 2012 750
Yes, you can fit a speedo cable and pedometer into a Renault Clio 2001 model. You will need to order the part that is made for that make and model from your local auto parts store.
no
No, there calipers are different. you can order the correct pads @ www.pdmautoparts.com
will 160/80-15 fit honda magna
As long as you reuse your spacers from the 94 CBR on the new 98 rim, it should work. However, you should look to see if both or them had speedo-cables. If the 94 has a speedo cable and the 98 does not (electronic), then the 98 wheel might be missing the slots that the speedo gear fits into.
This could be done with some minor modifications.
To the best of my knowledge and also checking with Cobra and Show Chrome, no they will not fit
speedo connected to gearbox and connected to other end not brken but not working
yes yes
No, the frame size of the two bikes is different.
should be 2002 - 2004