Want this question answered?
ebay, about £15
How to remove Window Winder Handles from VZ Holden Commodore
sounds like you window winder spring attached to your winder might be broken or the cogs on the winder have heaps of wear eg not touching sounds like you window winder spring attached to your winder might be broken or the cogs on the winder have heaps of wear eg not touching sounds like you window winder spring attached to your winder might be broken or the cogs on the winder have heaps of wear eg not touching sounds like you window winder spring attached to your winder might be broken or the cogs on the winder have heaps of wear eg not touching
Begin by removing the inside door panel. Remove the linkage from the window winder. Remove the window winder retaining bolts. The window winder will come off.
Call your local used auto parts wrecking yard.
Between the window winder and door card there should be a plastic ring about 8mm wide. Push this ring away from the end of the window winder. The windes should now slide off
what is a window regulator on a 01 vw jetta
Remove the window regulator assembly from the door.Remove the motor from the regulator by drilling out the attaching rivets with a 3/16 in. drill bit.Connect the window motor to the regulator with 3/16 in. rivets.Install the window regulator assembly.
window regulator cable is broken need new regulator
HOW DO I REPLACE WINDOW REGULATOR MOTOR ON PASSENGER SIDE WINDOW
If like me you have the winder style windows not the electric then just get ya hands a little damp an slide the window ope with your hands until there is a gapt then pull it down. If its electric then i dunno sorry.
I do believe that 91 and 94 are the same procedure. have to remove the door handle and the window handle. there is a clip that holds the window handle. There are three screws that hold the unit (window regulator)in place. You will have to get the window up and out of the carrier and, pull the unit out. put the new unit in and,place the window in the carrier but, make sure the window is at the full closed position (that is where you need another set of hands) then, you tighten up the screw in the unit. The window is seated at the full closed position therefore when you tighten the unit up is wont twist. when I got someone else to replace the window regulator they had that window in the down position and the new regulator lasted about 2 weeks and then broke again... thanks mr mechanic....grin