answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2008-05-04 19:40:45

check the slave cylinder,if its dry add fluid and then press the clutchin and out about 15 times

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Still Have Questions?

Related Questions

What type of transmission fluid does a 1990 Toyota Camry need?

What kind of transmission fluid is used for a toyota camry 1990


How do you remove and replace the power steering pump in a 1990 Toyota Camry?

how do i replace a power steering pump in a 1990 toyota camry?


Where is the fuel pump located on a 1990 Toyota Camry?

The fuel pump on a 1990 Toyota Camry (4 cyl or V6) is located inside the gas tank.


How do you reset 1990 Toyota Camry check engine light?

how to reset oil timing on 1990 toyota


What are the timing marks on a 1990 Toyota Camry?

The 1990 Toyota Camry timing marks can be found on the main pulley on the front of the engine. The timing marks will be scattered around the outside of the pulley.


Can you swap a 2004 Toyota Camry inline 4 engine into a 1990 Toyota Camry?

no. it not only wont bolt up but the electronics are entirely different.


What is the fuel tank size in a 1990 Toyota Camry?

15.9 gallons


Where is the thermostat in the 1990 Toyota Camry?

1990 Camry 4 cylinder thermostat is located off the bottom intake hose connected to the engine block.


Where is the horn relay located on a 1990 Toyota Camry?

The horn relay can be found in the fuse box under the hood. The 1990 Toyota Camry horn relay is found in slot 12 and is rated at 10 amps.


Where is the transmission module on a 90 Toyota Camry?

The 1990 Toyota Camry transmission module can be found on the back of the transmission. The transmission module will be in the upper right-hand corner.


Where is fuel injector relay located on a 1990 Toyota Camry?

spark plug


How do you replace drive shaft on 1990 Toyota Camry?

tool for drive shaft


Will a 1988 Toyota Camry starter fit on a 1990 Toyota pick up 22r-e?

Maybe


Where is the intake air temperature sensor on a 1990 Toyota Camry?

The intake air temperature sensor is located on top of the intake. In a 1990 Toyota Camry the air temp sensor assures the ECU the engine is running at optimal temperature.


How much it cost you to change the radiator on Toyota Camry 1990?

I paid $500 to get it replace.


What causes a 1990 Toyota Camry to lose power?

There are a number of things that may cause a 1990 Toyota Camry to lose power. Some of the common things include adulterated fuel, spark plugs failure and so much more.


How can you bypass a faulty starter lockout switch on a 1990 Toyota Camry that is supposed to be activated when it works correctly by fully depressing the clutch?

Simple. Look up under your dash board follow the clutch pedal to the switch, pull it out, jam a paper clip it ins place. Your Toyota will now start in gear if you turn the key. :�


Where can you get a Fuse box diagram for 1990 Toyota Camry?

autozone.com has online manuals that have printable diagrams


Which direction is the crankshaft bolt turned for removal on a 1990 Toyota Camry 4 cylinder?

counterclockwise.


My 1990 Toyota Camry keeps overheating. What could be wrong?

Buy a thermostat and install it.


How do you change shift solenoid for a 1990 Toyota Camry?

The Camry in 1990 doesnt have a shift solenoid. It was controled by a hydraulic shift governor inside the transmission. So the trans. has to come out and be opened up.


Where is the PCV valve located on a 1990 Toyota Camry?

There is no PVC valve on the 4cyl Toyota Camry. ÊThe location of the PVC valve on the 6cyl is center upper engine area, mounted in the rear valve cover.


Spark plug gap 1990 Camry 4-cylinder?

The spark plug gap for 1987-1991 Toyota Camry: 2.0L, 4-Cylinder is 0.044.


1990 Toyota Camry car part identification?

Do you mean what a given part is called? If so, describe where it's at.


How do I find the engine size of a 1990 Toyota Camry?

The 4 cylinder is ( 2.0 liter ) The V6 is ( 2.5 liter )


Still have questions?