answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you fix a Xerox Phaser X6350 ATC sensor failure service code 009-383?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why does the service traction system and abs light come on 2004 impala?

Probably wheel speed sensor failure (in the wheel bearing assembly).


Why does my speedometer stop when check engine light comes on?

Possible failure of the output/vehicle speed sensor.Possible failure of the output/vehicle speed sensor.


Will a code P0340 stop the engine?

P0340 is a failure in the cam shaft sensor circuit. That can prevent the engine from running.P0340 is a failure in the cam shaft sensor circuit. That can prevent the engine from running.


What does the error code p0155 mean on a dodge ram?

Right upstream oxygen sensor heater failure.Right upstream oxygen sensor heater failure.


What are the most common problems with 1998 Mazda Millenia S?

most Ive seen and experienced are - TCS Light - Knock Sensor Failure - O2 Sensor Failure(s) - Auto Steering tilt Failure (motor) - ECG Valve failure


Computer reads taillight failure but they all work?

Sensor failure, or data communications failure. Possible computer software issues.


Where is the ignition failure sensor in a 01 stratus rt?

The ignition failure sensor in an 01 Stratus RT is located above the condenser. It is near the ignition coil. ?æ


Why would crank sensor work after pouring water on it?

Sensor failure is often heat related , when crank sensors first start to go out they often have an intermittent failure when the engine is at full operating temperature. You are cooling the sensor with water.


Where is the IAT sensor on 2002 Mercury Mountaineer?

The Intake Air Temperature (IAT) sensor is incorporated into the Mass Airflow sensor. You cannot service the IAT sensor alone, you must actually service the Mass Airflow sensor instead. The Intake Air Temperature (IAT) sensor is incorporated into the Mass Airflow sensor. You cannot service the IAT sensor alone, you must actually service the Mass Airflow sensor instead. The Mass Airflow Sensor is located at the corner of the air filter housing where it meets the air intake duct.


What does it mean when your check engine light comes on it reads heated oxygen sensor bank?

There is a failure in the oxygen sensor heater.


Where is the brake light failure sensor in a 1997 acura 2.2 cl?

The brake light failure sensor on a 1997 Acura 2.2 cl is located on the rear of the car. It is on the back of the left rear lamp assembly.


2000 alero when I drive it I can't get it to do more than 40 miles per hour whats the reason?

Sounds like its gone into service mode. Either a Lambda sensor failure or a failed catalytic converter.