If it is the hydraulic cylinder itself you will have to replace it. If it the boom arm a capable welder should be able to repair it.
These have to do with the hydraulic density. In automobile, the density increases therefore making the hydraulic ratio to displace more than any hydraulic ratio in a displacement.
Hydraulic drive systems like gear pumps, rotary vane pumps, screw pumps, bent axis pumps etc. One real life example of hydraulic pumps is the brake master cylinder in a car. You also see hydraulic pumps in excavators.
It can not. Generally use press brake to bend sheet metal. Press brake has 3 kinds of series. Manual press brake by foot, mechnical press brake, hydraulic press brake.
Yes, a torque wrench is a precision instrument (or tool). -If damaged or even slightly bent it may give incorrect readings. It should always be kept in a separate case or box, nut just flung in a toolbox with over heavy tools (as I sometimes see)
The pipe has been bent in a former, no corner piece is then required.
These have to do with the hydraulic density. In automobile, the density increases therefore making the hydraulic ratio to displace more than any hydraulic ratio in a displacement.
Frame straightening machine
It could be some sort of liquid in the cylinder. It will cause it to hydraulic and bend rods.
The Bent Pyramids' angles were calculated incorrectly and would be too heavy for its' height. By the time this was realized, they changed the angles at the top to make the sides meet.
Judas Priest released Killing Machine/Hell Bent for Leather in 1979.
You need a tubing bender, but it can be bent.
A machine with 2 wheels and a motor operating a rotary plough (basically a series of bent 'claws' fitted to axle driven by motor)
An alignment machine would be the best way.
Get a reading on the alignment machine. Caster reading
A good body shop with a frame machine can do it if it is not twisted like a pretzel.
Your machine may require service, or a needle may be bent. Inspect the stoppage area to determine how to unblock the carriage.
Contact a good autobody shop that has a frame machine and have them look at it and give you their opinion.