Bronco pump taps aren't the most reliable keg taps in the world - the plastic cylinder that you depress to "pump" it can often get stuck at its lowest level making it impossible to get to your beer! Fortunately, this is a pretty easy fix.
First, look for the big plastic ring at the base of the cylinder. Plant a wedge (knife, etc) into the small crack where the ring meets the unit and leverage it upward to pop it off easily. Then the fully depressed cylinder should be visible.
Now it is a matter of wiggling the cylinder back and forth until it pops up and out of the unit. Once you get this far it should be obvious what the problem is. There are two possibilities:
1. The rubber seal around the cylinder has slipped out of its guiders and the friction prevents the cylinder from moving up and down. To fix, simply re-thread the seal and you should be good.
2. The cylinder itself might be cracked which pushes out on the plastic ring so it can't fully extend. All you have to do is file down the inside of the plastic ring a bit to give the wider cylinder more clearance.
Once you've done this just put the spring and cylinder back in the bottom of the chamber and pop the ring back on. Good as new! Now get back to partying.
On a 1992 Ford Bronco : The electric fuel pump is INSIDE the fuel tank
how do I replace a fuel pump on a 1993 Ford Bronco 302 5.0 L
If it is the same as the ( 1996 ) Ford Bronco : ( Relay # 2 is the fuel pump relay )
The fuel pump is located in the tank
first check your fuses and fuel relays make your power to the pump. check the fuel reset swich. i good manual would be a good start..
In the tank
A wiring diagram of a 1989 Bronco 11 fuel pump can be purchased from most auto parts stores. It can also be found in do-it-yourself repair books for a 1989 Bronco 11.
in the gas tank
In the gas tank
Where is the leak? From one of the hoses? Replace it. From the pump? buy a rebuild kit for $12.00 and rebuild your pump or buy a rebuilt pump for $50.00 and swap it out. From the steering gear box? Remove it and replace the seals or replace it with a rebuilt box.
On a 1996 Ford Bronco : The ELECTRIC fuel pump is INSIDE the fuel tank * it is installed through an access hole in the top of the tank
There are many parts that make up a keg tap. This includes a beer line, a faucet, a pump rod, a hand pump, a tap handle, and a pump to coupler connector.