Want this question answered?
Set fire to it!
To fix a Toyota Sienna driver's side seat belt that is stuck, you might need to pull the entire belt out slowly until it is completely extended. Then, allow the belt to retract slowly.
To fix a stuck seat belt on a 2000 Dodge Durango, pull on it to release its auto lock function. Pry off the plastic cover that hold the seat belt mechanism with the use of a screwdriver, loosen the stuck belt, and put back in place. ?æ
Pull off the panal that houses the belt and check for twisting or binding.
The spring may be locked or broken in the seat belt mechanism. You can order this part and replace them yourselves or have them replaced for a low amount.
Replace the seat belt.
replace the seat belt
Pull the vinyl cover off of the seat belt, then roll the seat belt back on the roller.
Take it to the dealership, its a safety issue and is better left to the dealership to fix because if it isn't fixed right it is very dangerous for obvious reasons
fix it when you can safely and avoid collision and cops/ pull over at the correct time and secure it again
Plug The Seat belt in.
I have the same problem in a 2000 Sebring. You can't pull the seat belts out of the seat's retractor. According to the owner's manual the seat belt mechanism needs power on to allow the seat belts to extend. When you open the door or put the key to accessory position power is allowed. The fuse for the seat belts is listed with the flashers and the flashers work ok. I will post more after I fix it. There is a wire connector under the seat that controls the seat belt mechanism. You have to make sure it is connected otherwise the seat belt will remain in the stuck position. I had the same problem, seat belt was stuck and I couldn't use it. I discovered the wire wasn't connected under the seat. Once I reconnected it and turned on the car I was able to pull the seat belt out.