answersLogoWhite

0


Best Answer

tumblers are merely brass pins. go to any hardware store & purchase a small tube of graphite lubricant. it is a dry lube - do not use oil as it will make your tumblers gum up over time. simply squirt a small amount of graphite into the lock, then insert and remove the key a few times. if this does not free the tumbler, using a very fine pick or perhaps another key with a different cut, attempt to push the tumbler further into it's hole. once some of the graphite works its way into the hole, the tumbler will pop up like normal.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you fix a stuck ignition key tumbler on a 1974 corvette?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

The ignition key is stuck in your 1974 corvette how do you fix it?

Put it in reverse.


How to replace ignition switch on a 1974 ford bronco?

"First, insert the key into the ignition tumbler. Proceed by turning the key counter-clockwise until the key is in the "accessory" position. Using a paper clip or pick tool, depress lockout pin while turning the key counterclockwise approximately 1/8 of a turn. The tumbler should then release. Remove tumbler from ignition switch. Note the position of the tumbler as it is being removed from the ignition switch, making sure not to turn the key as it is being removed from the switch. Align the new key and tumbler in the same position. Be sure the flat edge at the end of the new tumbler matches the same position as the old tumbler. You will more than likely need to suppress the pin on the face of the tumbler as shown in video in order to match the same flat edge position. " - Copied with permission from tomsbroncoparts.com. They also provide a video of how to do it here: http://www.tomsbroncoparts.com/pages/instructional-videos/how-to-install-a-ignition-switchtumbler-into-a-1966-1977-early-ford-bronco/


Does a 1978 Corvette door fit a 1974 Corvette?

Yes.


Will a 1979 Corvette column interchange with a 1974 Corvette?

Yes.


Does a 1974 Corvette have airbags?

No


Where can someone find pictures of a 1974 Corvette online?

Some of the online places that one can find pictures of a 1974 Corvette are Corvette Trader and WebCars. The 1974 Corvette can also be found where different members of a forum may post such as at Digital Corvettes.


Will 1976 Corvette front grill fit on a 1974 Corvette?

Yes.


Can you replace a 1969 Corvette frame with a 1974 Corvette frame?

Yes.


Will 1972 Corvette t tops fit on a 1974 Corvette?

Yes.


How much did a 1974 corvette cost in 1974?

base $6,000


Does a 1974 Corvette a vented gas cap?

NO


Where is fuse panal on 1974 Corvette?

The Fuse Panel in a 1974 corvette is located to the left of the brake and clutch pedals under the dash near the kick panel.