Chevy Blazer
Chevy S-10

How do you fix brake lights on 1995 Chevy blazer?

789

Top Answer
User Avatar
Wiki User
Answered
2009-12-10 02:33:00
2009-12-10 02:33:00

Check the fuse, check the bulbs and check the brake light switch, it should be one of those.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


DRL = daytime running lights


The hazard switch and the turn signal and brake lights are all incorparated, chances are the 3-1 switch is broke internally check all fuses



it is a 1995 Chevy blazer and it will not go into park. have to use the emergency brake when stopped, and neutral to start it


It is your multifunction switch that has gone out. It is located in the steering column. I used my emergency lights and it blew out brake lights, turn signals, and emergency lights. In newer models Chevy did a recall not so for our older models. Mine is a 1995.



Where is the idle speed motor located at on a 1995 chevy blazer?


Your brake light is probably brake fluid low or emergency brake on. Rear brake lights are replaced by removing the lens and replacing the dual filament bulb.


where is the fuel shut off swith on a 1995 Chevy s -10 blazer at


The 1995 Blazer was rated at 5000lbs towing capacity.


I assume you have checked/replaced the bulbs. Take a cicuit tester and check the wire harness connections under the bumper and around the trailer connector if you have one. The problem must be at that area IF all your other lights are working as you said.


Original manufacturer's tire size for a 1995 Chevy Blazer are P205/75R15 97S.




where can i buy a transmission dip stick for a 1995 chevy blazer



Rear loom ground not contacting. Bulbs burned out or missing. Brake light switch or connection to it is fubared.


either dimmer switch or blown fuse If you are saying that the tail brake lights are working but the third brake light is not....It may be a defective turn signal switch in the steering column.


There are several, which one are you looking for?


The stock gear ratio for a 1995 Chevy Blazer is 3.73. This provides a good balance of fuel economy and power to the rear wheels.


They are lined up like this on my 1995 Chevy blazer 4.3 L, V6 1,6,5,4,3,2


probably no because Chevy changed the type of fuel injection and it probably operates at a different pressure.


Its most likely the brake switch. Its a plunger like switch on the brake pedal. Its pretty easy and cheap to change.


I have a 1995 Nissan sentra and the brake lights were stuck on because of a switch that broke above the brake. the mechanic said it happens to alot nissans


Remove the tire and wheel from your 1995 Chevy. Remove the brake assembly. Tap on the brake rotor with a mallet or hammer. The brake rotor will slide off.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.