0
To fix high idle problem on a 1996 VS Commodore, first locate the idle air control valve. Unscrew and unplug electrical connector running to the valve. Turn the valve over and clean the sensor for debris.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
How do you fix high idle speed for 1996 jaguar xj6?
May be idle position sensor.
How to fix a rough idle Nissan?
why does my vr commodore idle rough when at complete stop
How do you adjust the idle on a 1996 Ford van?
This engine will be fuel injected. This means that if the engine will not idle at the correct speed there is something wrong with the fuel injection system. The most common problem leading to a high idle is a vacuum leak. The second most common problem is a bad or fouled spark plug If neither of these is the problem a scan with a correct tool may tell what component has failed .
Vn commodore stalls at idle on petrol?
Idle Air Control Valve would be a good place to start.
94 ford van 5.7 engine High low idle?
whats the problem for my 94 ford van engine high and low idle
When I turn my wheels left or right it idle high Why?
When I turn my wheels left or right it idle high because there might be a problem with the power engine.
What would cause a 1996 Chevy Corsica to idle high then idle fine after turning the engine off and on again?
check the soleinoid
How do you adjust the idle on a 1988 Chevy Cavalier 2.0 four cylinder?
You can not adjust the idle screw, it is sealed off at the factory. If you are having a high idle problem check for a vacuum leak or a bad idle air control valve. These will commonly cause a high idle.
Why is idle high on 1995 caprice at startup?
buy a toyota !! Problem solved
What is engine idle speed for 1996 Intrepid 3.5L engine?
Idle speed is automatically controlled by the PCM. It varies from 600 to 1000 rpm. If it is not in that range then it has an electrical problem or a vacuum leak.
Why does a four cylinder engine miss fire with the headlights and heater on high. The idle is already set high to compensate?
You have elecrical problem
How do you fix high idle problem on a 89 240sx?
If your idle was fine and then just became high, don't adjust the idle control screw. Your problem would be indicative of another issue. Perhaps a vacuum leak. turn the idle control screw to the left ... no neither of those.....your are getting air that is accounted for by the mass air flow sensor....there for its either a) throttle plate not closing or b) idle air controller stuck open.
