There should be a number of screws on the inner fender. Using a floor jack, lift the car and remove the front wheel. Look to see if any screws are missing and replace them.
Pry up on the tensioner pulley.
The fender is glued on about 3 in. down on the side at top. bolts on at bottom and on the front bumper. To break the fender lose at the top and off of the inner fender well use a puddy knife and a lot of care. After you remove fender sand the bonding strips and trial fit the new fender in place. Clamp it in place and draw lines so you can install in the same place. Remove fender. Put bonding glue on the bonding strips and on the inner fender. Put the fender back in place using the lines that you drew to line it back up. Clamp in place. Bolt the bumper back to fender and at the bottom. Wipe excess bonding glue off the fender and top surround and wait to dry. Sand and prep for paint. It know where as easy as bolt off and on and paint. Its A lot of time and work. Hope this helps
The minimum thickness of brake shoes on a 2002 Ford Focus LX is 0.32 inches. Whey they fall below this thickness, they lose much of their stopping power.
Unless you want to lose your $1200 air bag, take it to an authorized mechanic.
run straight pipes. illegal in many states. will lose torque, but will be very loud.
you have to buy and install adjustable cam gears. but if you adjust it improperly you will lose power/gas mileage.
Reagan did not lose to Ford. Ford lost to Carter, and Carter lost to Reagan.
Clogged fuel filter, dirty injectors, bad spark plugs (should be changed every 100K miles).
I had a similar problem in a taurus. I had to replace the alternator.
Blown head gasket, burnt or bent valve, spark plug loose, busted piston, worn or broken rings,
Gerald Ford pardoned Nixon.
33# all 'round. Make sure you keep them inflated as such, or they will wear out on the edges very quickly. Rubber is porous and they will lose pressure.