Want this question answered?
Resynchronize it by holding down both the lock & unlock buttons at same time for at least 7 seconds. Doors should lock & unlock once to confirm that resynchronization worked.
where is the fuelpump on a Chevy mailbu
you have to resync the remote after changing the battery, stand next to car hold the lock and unlock buttons down for about 7 seconds or until you hear the horn chirp, thats it good luckSource(s):Impala LS owner
KOBUT1BT is the FCC ID# on the back of keyless entry remotes for 2000-2001 Chevy Full Size Pickup/1998-2004 Chevy S-10 Pickup/2000-2001 Chevy Suburban & Tahoe. And it's easy to program these remotes without having to pay dealership "ripoff" prices. 01: Close all vehicle doors02: Insert key into ignition03: Press and hold driver's door unlock switch04: Cycle igniton On_Off_On_Off05: Release unlock switch Doors will lock and unlock to confirm programming mode 06: Press and hold lock & unlock buttons on keyless remote Doors will lock and unlock to confrim keyless remote programmed 07: Release lock & unlock buttons on keyless remote Repeat steps 06 & 07 on all remotes you have for vehicle because programming first remote erases programming on additional remotes. 08: Turn igniton on to exit programming mode Up to four remotes can be programmed to one vehicle.
Take the remote apart and it says to push the buttons once each or twice each try this
I looked up the owner's manual - I also have a 2001 Chevy Astro Van, and there is a setting called resyncronization. If you hold both buttons down, the lock and unlock, for 8 seconds, it will recycle the alarm and synchronize it to the key fob remote. When the alarm goes off, just hit unlock twice like you normally would, and it should be fixed.
Most likely to reprogram the remote you need to take it to a Chevy Dealer and they can do it there... cost ranging from $40-$90...... I had the same problem after replacing the battery & the remote still not working.... I reset the remote by holding down both the lock & unlock buttons @ the same time for about 10-15 seconds.... this resets the locks inside the truck... you should hear the locks lock & unlock if so then your remote should work fine... if not then i suggest taking it to a dealer... hope this helps!
Could be a bad or worn out remote. You could try synchronizing your remote (from my 98 manual) : stand close to the truck and simultaneously press and hold the lock and unlock buttons for at least 5 seconds. The door locks should cycle to confirm sync. The only other option they off is to see the dealer. Hope this helps.
beleive there is a recall for that
Where the upper radiator hose connects to the engine you will find the thermostat.
Put the appropriate key in the door, and turn. Or use the remote if you have keyless entry.
Lock the truck with remote then unlock truck manually with key