0
How do you fix the mounting exhaust rubber for Renault Megane?
Wiki User
∙ 11y ago
Buy a new one for about £20, problem solved !
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you replace the rubber mounts on the back of the exhaust on a Renault megane?
hi mate ours went the other day cost 18 pounds for a new one its a metal bracket with rubber in side theres 2 bolts holding it to the under side of the car look on ebay for megane rear exhaust rubber ( they have a strap thing on them ) so you cant just fit any old thing This is a really easy thing to do. 1st - buy the rubber mounts from ebay. I just bought 5 in a pack for £9 incuding postage 2nd - remove the old one by sliding it off of the metal hanger on the exhaust and then twisting the other end 90 degrees. It will then pull out of the hole. 3rd remove the plastic insert form the old rubber hanger, grease it and slide it into the new one. grease the other end of the rubber mount as well. 4th - slide it back onto the exhaust support first. 5th - twist the other end 90 degrees and push it into the hole in the bracket. Job done - About 10 minutes
What wrench do you need for the caliper mounting bolts on a 1996 mercury villager and what are the rubber collars for?
You need a 'Star' or 'Torx' wrench. The rubber collars keep dirt of the caliper mounting bolts so the caliper can 'float'
Water ingress Renault megane?
if your megane has a sunroof, remove front wheel on side of pooling water. then remove the 2 small torx screws at the bottom of the wheel arch in line with the sill. if you can pull back the plastic wheel arch cover enough to see a pipe with a rubber bung on the bottom with a slit in the bottom of it. remove the bung & you should have a load of muck that will have gathered there & possibly water. The problem is common on the megane. Try & make the slit or hole on the bung a little larger so that any muck will flow freely. Viola! job done!
What is the sump plug washer caled on a Renault scenic the one with the rubber insert?
dowty washer
A ground strap is typically used with what type of motor mounting system?
With rubber motor mounts.
There is a loud noise in rear when hitting a bump what could it possible be?
Suspension mounting rubber needs replacing.
How do you reduce vibration at internal combustion engine?
You can't without extensive modifications, adding counter balancers, etc. The cheapest way is to isolate the vibration by mounting the engine on rubber bushings. Place the bushings between the engine and the and the mounting surface - like big rubber washers.
Has anyone fixed a leaking sunroof on a Renault Megane 1.6 sport r reg?
LEAKING SUN ROOFFIRST YOU NEED TO NO WERE THE LEAK IS. IF ITS BETWEEN THE FRAME AND THE BODY IT MEANS THE HEAD LINEING WILL HAVE TO COME OUT TO GET TO THE SUN ROOF FRAME WHICH WILL THEN NEED TAKING OUT AND RESEALING. IF ITS BETWEEN THE FRAME AND GLASS YOU NEED TO TAKE THE GLASS OUT AND REPLACE THE RUBBER SEAL OR JUST REMOVE THE RUBBER SEAL CLEAN IT AND THE CHANNEL IT FITS IN PUT SOME SILICON SEALANT IN THE CHANNEL AND REFIT RUBBER BEFORE THE SEALANT GOES OFF HOPE THAT HELPS Probably just the drain pipes need cleaning out.
Name the last driver who win a Formula 1 title with Michelin rubber?
Fernando Alonso (Spain) Renault, 2006
What song starts with the sound of car exhaust?
Record: Burn rubber on me Group: The gap band
What is a radiator gasket?
A radiator does not require a gasket so this may refer to a rubber mounting that prevents the radiator from jolts and damage.
Why does your new car smell like burning rubber?
My new car did not smell like burning rubber! When I had a gate smelling like burning rubber, a rubber belt was stuck and instead of turning with a piece of machinery, was caught. I would check the belts in the front of the car and look for one with a worn or burned place on it. It could also be a wire or tube resting on an exhaust manifold or on an exhaust pipe.
