answersLogoWhite

0


Best Answer

the window is both side power is not working

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you fix the window and the lift drive motor being disconnected?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

2000 silverado window motor runs but the window is loose and does not move?

The drive gear is broken in the window motor. Remove motor and install gear kit.


95 Nissan Maxima - Window goes up normal but when you try to put it down you hear the motor but the window comes down from gravity not from the motor?

Sounds like it is your window motor drive box. I have had to repair three in my 95 Maxima. There is no longer a good bond between your rubber isloation wheel and the output drive. This is the part behind the round aluminum cover adjacent to your electric window drive motor.


Why would a power window motor run but not raise the window?

Because the window probably jumped the track or the track has become disconnected somehow. Pull the door panel off and you should easily be able to determine what it is and fix it. well the motor is connected with some belt or any other thing to move the window may be that belt got sliped from motor or broken due to this motor is running freely.


Your window on your right hand drive 2000 jeep Cherokee won't go up or down what could it be?

window motor


How does the window mechanism works to get the window up and down It has power but something seams to be either broken or disconnected Could it be the cable?

Check the clip fron the window to the regulator. These will break off and you will hear the motor working but the window will not go up or down. You can replace your regulator and motor as one unit for little cost, if broken. You might get away with just replacing the clip to your window/regulator.


93 Topaz GS-Power window motor runs but window will not operate What can be done to correct this?

Take out the motor and check the 3 nylon bushings that are inside the drive gear.after removing the 3 bolts that hold the power window motor to the widow bracket,remove the motor from the door and there is a small Philips screw below the drive gear.remove this and take off the cover.now remove the drive gear,it just lifts out.you should see 3 nylon bushings.if you see bits and pieces you'll need new bushings.


Your drivers window wont go down When you push the button to roll it down it makes noise but the window doesnt move What could the problem be?

Sounds like the motor is disconnected from the window, or the gear may be stripped. == == == == go to a place that works with motors and ask what might be wrong


1993 Mazda 626 driver side power window not working....but works all other windows?

Check to see if you are getting power to the motor - if so motor is badIf not could be a bad switch or broken or disconnected wire


How to remove a Ford bronco rear window motor?

I'm not sure what year you have but for my 94 xlt it was as simple as: -lower the window so you can open the tail gate. -remove the access panel -now open the window half way -there are 4 bolts, 2 on each side that connect the window to the mechinism that raises and lowers it. remove those 4 bolts. -open the window fully once disconnected from the mechinism *MAKE SURE TO SUPORT THE WINDOW WITH BOX'S OR SOMETHING* -diconnect the wiring harnes to the motor -remove the 3 bolts that hold the motor in place. -and slide it out


1994 Grand Marquis drivers window motor works but window doesn't go down or up but the window does work itself downward while driving so what could the problem areas be?

Electric Window problemIf you haven't checked already, check to see if the window is in the track and not out of the track and then check the regulator to see if one or more teeth are broken or may have come disconnected. Hope that might help also sometimes the motor works but doesn't have enough strength to lift the window had that problem on my 1987 Nissan wagon had to rebuild the window motor. or if it is on track the cable linkig might have snapped my 95 did same on driver window


How do you roll up the window on a 99 eldorado if the drive motor is broke?

Use a side cutters and cut the cables. Tape the window up until you can replace the regulator.


Why does window fall down on 2001 Nissan Xterra?

The window will often fall down on a 2001 Nissan Xterra due to a faulty drive motor. This causes the tension that holds the window in place to release.