0
Probably this is caused by a faulty Motor mount or Transmission mount. Inspect the mounts and if faulty, replace them. They are not repairable. If you have an old car that you cannot find new ones at the McParts store, check out the local Junk Yards......there are sometimes cars other than yours that uses the same parts. Ask the Man for an interchangeability list.
HTH
Chuck, CABGx3
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
How do you adjust idle 1990 Ford Festiva?
Turn the Idle Adjusting screw.
What causes vibration while in idle on a 1993 Ford Escort?
most likely you have a missfire.
How do you set the timing and idle speed on a fuel injected 1999 Ford Festiva Trio?
May be controlled by computer and non-adjustable
How do you adjust a fast idle on a 1989 Ford F150 302?
probably a bad idle air controller.
What can cause 1989 Ford F-250 to idle high?
a vacuum leak can cause high idle
Vibration in front of engine at idle 2004 Camry?
car run good but has a little vibration idle or running
Why won't your 1989 Ford F250 with 5.8 L engine idle?
sounds like a bad idle control sensor
Should you be worried about a 2005 sierra 1500 that has a 0.5 rpm idle with a slight vibration while idling?
If you have average mileage on it, you should go get it checked. That is too low for an idle. The vibration is probly from the low idle.
What is the idle speed on a Ford Festiva?
check under the hood as there should be a sticker, but without year and transmission style i cant tell you for sure. For a manual 1993 its 700 rpm. hope this helps ...{ASMDEMON}
Where on 300 6cylinder of a 1989 ford f 150 where is the idle air control valve located?
on the side of the throttle body.
How do you get a 1989 Ford Laser to idle?
you have to turn the idle screw down ?? ? ? ? ? ? ? ? ? ? there are 2 of them. one on the right and one on the left. the left one is general idle and the one on the right is for air-conditioning idle and high power output idle ( rev higher ) A vacuum line may have come off if it has started revving.
What would cause a Ford Bronco II 1989 V6 29L to idle at 2000 rpm even though the idle has been set as low as possible?
Large intake vacuum leak or idle air bypass valve stuck open
