Ford Laser

How do you get a 1989 Ford Laser to idle?

575859

Top Answer
User Avatar
Wiki User
Answered
2010-09-14 03:59:11
2010-09-14 03:59:11

you have to turn the idle screw down ?? ? ? ? ? ? ? ? ? ? there are 2 of them. one on the right and one on the left. the left one is general idle and the one on the right is for air-conditioning idle and high power output idle ( rev higher ) A vacuum line may have come off if it has started revving.

001
🙏
0
🤨
0
😮
0
😂
0

Related Questions


probably a bad idle air controller.

a vacuum leak can cause high idle

sounds like a bad idle control sensor

It located above the sump plug

Behind engine, under the inlet manifold.

Not sure what an absober is. More info please.

a ford laser a ford laser

1342 ai is the case with all 4 cyl cars

right side in fuse box and you can see which number is on little board.

0.30 inlet and exhaust. If EFI then it has hydraulic tappits that self adjust. Chris

They are not supposed to be reset because they are factory set to comply with emission laws. yes but where is it located

The Ford Laser is, in fact, a restyled version of the Mazda 323. Ford owns 25% of Mazda. In the U.S. it is a Mazda 323. The Ford Laser in the U.S is called a Ford Escort.

Laser Quest was created in 1989.

The replacements for the motor of ford laser kb are JUKI or SINGER

The firing order for the 1983 Ford Laser is 1342.

check the coolant and water levels. if they are all good, there may be a blockage in your radiator or pipes to the raiator

The most common fault is the ignition module in the dissy which breaks down when warm.

remove the old belt and remove your trouser's belt off and put into the fan

where can i locate the body control module in a 95 ford laser


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.