It is easiest to remove the thermostat and drain the radiator by removing the lower hose. Dispose of the coolant properly. reinstall the lower hose and run water from the garden hose through the engine with it idleing until it runs clear. Then remove the lower hose to drain the radiator and reinstall the thermostat with the spring toward the engine. Then fill the radiator with coolant and start the engine up and top off the radiator after the thermostat opens. You should end up with about a 50/50 mixture of coolant and water. Good Luck Joe
You can find the 1991 Buick Skylark radiator drain plug on the bottom of the radiator. The radiator drain plug will be in the center of the radiator bottom.
If it has a coolant tank, that's the "cap".
The thermostat on a 1991 Buick Skylark is located near the engine. To find the thermostat, follow the top radiator hose directly to the thermostat.
a 1991 buick skylark has 4" speakers in the dash and 6x9's in back
how do you replace a ignitionswitch tumbler 1991 buick skylark
where does a clutch relay seleniod go in at on a 1991 buick skylark
I'd say about 2.5 tons.
Under dash with fuses. Very hard to see.
The PVC valve for a 1991 Skylark should be located on the top of the valve cover. It is a plug in type, twist and pull to remove.
a round one that you can order online
Probably a worn-out or clogged heater core.
Either a 2.3/2.5 4cylinder or a 3.0 V6