Out of what? Is it a cartridge fuse, fuse block, disconnect panel? Turn off power and use fuse pullers for cartridge fuses. If its an old and corroded fuse block in your house, you would be wise to call someone who has the proper protective equipment to remove it.
A fuse rating is normally the 120% of the rated full load current. So, 4 amps times 120% is (4x120%) = 4.8amps
That depends on the voltage you use. If there are 120 volts, the power equals voltage times amperage. 120 volts times 15 amps = 1800 watts. Cheers ebs
Use the correct fuse and nothing else.
A fuse is a safety device which is designed to blow (fuse) if a larger current than it is rated for passes through it. So a 10 amp fuse can pass anything up to 10 amps.
Depends on the size of the fuse.
You don't it is a 100 amp fuse.
First, locate the fuse box. Then, once inside the fuse box, locate the 120 amp fuse. Remove it by pulling it straight out. Lastly, place the new one in place of the old one.
The person who said to read the owners manual, obviously has never replaced the 120 amp fuse. It is held in with a screw from the bottom of the fuse box. It would never mention something like this in the owners manual.
Disconnect the battery. Remove the fuse board cover. Remove 3 bolts (10mm) retaining the fuse board. Lift the fuse board - underneath, either side of the 120 Amp fuse, remove the bolt (13mm) which is passed through the 120 Amp fuse legs.
It will draw over 18 amps and will blow a 15 amp fuse.
fuse number 1 is 10 amp fuse 2 is 25 amp fuse 3is 25 amp fuse 4 is a spare fuse 5 is 10 amp fuse 6 is a spare fuse 7 is 20 amp fuse 8 is 25 amp fuse 9 is 20 amp fuse 10 is 5 amp fuse 11 is 5 amp fuse 12 is a spare fuse 13 is 5 amp fuse 14 is 15 amp
A fuse rating is normally the 120% of the rated full load current. So, 4 amps times 120% is (4x120%) = 4.8amps
1 amp
NO! Using a larger amp fuse defeats the purpose of the fuse to protect the wiring in the circuit. This can cause a fire. Always use the correct amp fuse for that circuit.
NO! Using a larger amp fuse defeats the purpose of the fuse to protect the wiring in the circuit. This can cause a fire. Always use the correct amp fuse for that circuit.
That depends on the voltage you use. If there are 120 volts, the power equals voltage times amperage. 120 volts times 15 amps = 1800 watts. Cheers ebs
absolutely not