There's a snap-ring on the end of the shaft. Make sure the open part of the ring is pointing down when you insert it into the trans.
You could always take it to the shop You could always take it to the shop
volume is all the way down o speakers do not work
You have to turn your itouch of all the way
Something has happened there. If it isn't in all the way it can do that.
No! That way if you dump her and she gets mad at you she wont know all about you.
first off whats it on... could be a gasket in the way!
when you turn the wheel all the way to the left or right you here a popping noise when the car is rolling.
yes, there is a way
Only if you want it to work.lol. Yes it does, if not you will leak fluids and put the axle on a bind making it wear faster or break. it could even damage the splines in the tranny
On most cars its possible to remove the lower control arm without removing the axle nut. however sometimes the nut on the ball joint stud wont come off because the axle is in the way. If that happens try loosening the nut as far as you can then pop the ball joint loose. When it drops it will allow you to finish removing the nut. Good luck Tomtv
No way to answer without knowing model. You could referring to anything from an S10 all the way to a tandem axle Top Kick.
If you do that the trucks wont turn, wheels wont rotate, and the board will get stress fractions from the nuts being to tight so you probably wont be going anywhere