answersLogoWhite

0


Best Answer

Not knowing the year, make, model and engine I suspect you have more parts to remove.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you get alternator out have everything disconnected and is loose but wont come out the top or bottom?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you get the battery light to turn off on a 1998 Chevy Malibu?

When this light stays on, it is telling you the system is not charging. Possible bad alternator, battery, or loose or disconnected wire.


You changed the alt now the car still stalls when it run for a while it shut downs?

While replacing the alternator a vacuum line might have been disconnected or something like that... inspect for something loose close to the alternator dave


How do you replace the alternator on a 1994 Chevy Suburban?

There is a belt tightener on the alternator which must be loosened to take the belt off. After the belt is loose, remove the bottom mounting bolt and the alternator is off. you will also need to remove the wiring.


What keeps a Mitsubishi eclipses from running after you just changed the alternator?

Did you bump something loose, and made sure you hooked everything back up?


Battery light goes off you you acselerate?

Alternator belt is probably loose and slipping. If you can turn the alternator by hand and the belt slips its too loose. Retension alternator belt


Why does the battery not charge?

Corroded or loose battery connections, loose alternator drive belt, defective alternator, or dead cell in the battery.


Can a bad alternator cause a cam position sensor error?

If the alternator is producing AC waveforms (the regulator has broken-down and not rectifying AC supply from the alternator - you'll have weird stuffs going on. You may loose your car ECU, body controller and everything else.


Battery light comes on at 5000 rpms?

alternator, or a wire to alternator loose


What causes alternator battery light to come on and then off itermittently?

Can be loose or corroded battery connections, loose drive belt, or the alternator is failing.


How do you replace an alternator belt on a 1987 SAAB 900?

You will need to loosen the alternator belt with the tensioner pulley. When the tensioner pulley is loose the alternator belt will become loose. Put the new alternator belt on and tighten the tensioner pulley.


Can a pcm loose its memory?

Yes. If the battery is disconnected in most vehicles, the PCM will loose it's memory.


What causes alternator belts to break and squeal on a 1984 2.5L SE Pontiac fiero?

Make sure both the top and bottom bolts are tight, if the bottom is loose the alternator can "wiggle". Also I have noticed that the top bolt may sink into the slot provided for alternator belt adjustment. I put a slightly larger diameter thick washer on the top bolt and it cured "the agony of the screech"!