On newer models, about 1997 and later, you need a diagnostic scan tool such as an OBDII that will connect to the engines control module. These are available for purchase at most auto parts stores, starting at around $60.
On some older models, you can cycle the ignition as follows to get fault codes:
Cycle the ignition twice from ON to OFF, then back to ON within 5 seconds. The check engine light will flash any two-digit codes that are stored in memory, starting with code 88 (8 flashes, followed by 8 flashes). When the list of codes is finished, code 55 will be flashed (5 flashes followed by 5 more flashes). A list of codes can be found in either a Chilton's or Haynes repair manual for your model year, or probably available from your Dodge dealer. Or, just ask above.
You use an OBD scan tool.
ignition coil circuit failure
You need to have the engine and abs checked for codes.
ignition coil circuit failure
A 1991 Dodge Dakota will have either a V6 or a V8 engine.
Scan for codes, some parts stores do it free....Advance auto.
There is no difference in a 1995 dodge dakota with a 3.9 v6 engine and a 2000 dodge dakota with a 3.9 v6 engine and you can exchange the newer engine with the older one.
obd (1) codes are generic, same for all domestic obd(1) two or three digit codes
Yes, depending on engine SIZE. (;
Yes. A 3.9 v6 engine from a 1995 Dodge Dakota will fit into a 2000 Dodge Dakota with a 3.9 v6 engine. You will have to swap the intake and exhaust manifolds along with all sensors and fuel rail though.
There are pages and pages of things that can turn the check engine light on. You need to have it checked for codes to know what the cause might be.
If you turn the igition on-off on-off on-off in less than 5 secs, the check engine light will flash the codes.