Chevy Blazer S-10

How do you get rid of the rust around the Fuel Filter of a 1993 Chevy Blazer s-10?

252627

Top Answer
User Avatar
Wiki User
Answered
2005-11-06 06:59:39
2005-11-06 06:59:39

Have you changed the fuel filter or is it rusted and you can't change it? If that you need to spray it with some good lubracant to loosen everything up. They do make a liquid that you can buy at a parts store to nuetralize the rust. Make sure you don't get this stuff on your clothes or in your eyes as its very caustic.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Under the vehicle, bolted to the frame on the driver's side

Where is the horn located on a 1993 chevy blazer

It on the driver side right behing the headlight in the fender wall

My guess is fuel pump. Either that or a clogged fuel filter.

i need to find location of fuel filter on 1993 Chevy cavalier

Grab the filter with your hand or a filter wrench and turn counterclockwise.

if it is not on the drivers side of the engine, there may be a stock oil filter relocator that puts the oil filter right behind the drivers side headlight, you must remove the air filter box to see it.

A blown fuse can make your dashboard lights to not work in your 1993 Chevy Blazer Tahoe. A burned out bulb can also cause this.

Fuel filter may be plugged. Catalytic converter may be plugged. Engine may be in need of a tune up.

fuel filter is on drivers side on the line against the frame.

which fuse is for the fuel pump in a 1993 chevy s10 blazer

The fuel filter, on your 1993 Chevy 6.5 liter diesel engine, can be removed by turning the fuel filter to the left. The fuel filter will come off and can be replaced with a new filter.

When you change the fluid and filter it will hold, 4.2 qts (3 speed trans.) 5.0 qts for a 4 speed.

The 1993 Chevy S 10 Blazer IAT sensor can be found on the top of the transmission. The IAT sensor will be near the front of the transmission.

Is there a way to bypass the ECM in a 1993 chevy s10 4.3 vortec

if you have to ask this question, then you shouldn't attempt to change them...

Replace it with a new one, there is no repairing it.

There is no spark plug cap located on the 1993 Chevy Blazer. The spark plug gap for this vehicle varies depending on the type of spark plug that is used. The OEM spark plug gap for this year is 0.040.

by separating the lower balljoint and sway bar on that side

The ecm would be in the passenger side kick panel.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.