Take off the pad holder 7mm Allen and the main caliper holder 18mm, then tap around rotor with rubber mallet to loosen and pull off, make sure you use a coat hanger to hold up caliper, so there is no strain on the brake line and also be sure to remove metal clip on one of the studs before trying to remove the disc. RRR Wis.
Take the brake caliper off and it should slide right off or i might have two screws in the rotor in the center of it
Remove wheels Remove calioper mounting bolts Slide caliper off rotor Rotors will peel off hub
I just changed the pads and rotors on the wifes 2003 escape and it was stuck but you have to hammer the rotor all around and that will loosen it up ,you might want to spray some WD40 on before you start hammering
New car under warranty. Call the dealer.
Remove wheels Re-install 2 lug nuts to hold rotor in place Remove flexible brake lines Remove caliper mounting bolts Slide caliper off rotor
Remove wheels Remove caliper mounting bolts Slide caliper off rotor Peel rotor off hub
You have to pull that whole assembly apart to get to the bearings. The wheel comes off, then the brake rotor, then you have the hub assembly. The bearings are inside of that.
Ford dealer, service manual from an auto parts store, or off Ebay. Sorry, don't know of any freebees.
Should be "peel off" type Remove wheels Remove caliper mouting bolts Slide caliper off rotor Rotor should slide off hub
The Ford Escape went into production in 2000. So there is no 94 Escape
Remove wheel Remove caliper mounting bolts Slide caliper off rotor Rotor should slide off hub
To change headlight bulbs in a 2005 Ford Escape, first make sure the light switch is in off position and replace the passenger light bulb. Next, get to the driver's side bulb, remove the battery by holding it down, to be able to change the headlight bulb.