If someone has applied a lacquer to stop the brass from tarnishing,it's likely that they have used either acrylic or oil based clear from an aerosol can.(some of the acrylics are of good quality) You should be able to remove it with acetone and clean cotton rags.If a 2-part polyurathane is on it, it will need paint stripper, but this is unlikely.
Its worrying that there is mould in there in the first place!
You can pay for it to be chemical cleaned or ultrasonic cleaning an any brass repair merchants.
Paint stripper worked for me.
you can't you will have to get a new one.
Unfortunately, as far as I know, there isn't really a way to stop this. The best way to help prevent this is to be very careful with your sax, but it's virtually impossible to keep those pestering little scratches off your lacquer.
Depending on condition and any re-works, i.e. original lacquer >$ than a bad re-lacquer; anywhere from $6,000 to $11,000.
Bill Clinton played the tenor saxophone.
The soprillo saxophone.
The saxophone repertoire is any music written for saxophone, or transcribed for saxophone. This makes this music specific to saxophone and therefore playable on saxophone. Popular classical saxophone repertoire includes such pieces as Concerto-Glazunov, Concertino da Camera-Ibert, Sonata-Creston, Scaramouche-Milhaud.
Lacquer thinner will possibly remove it, chemical stripper will definitely remove it.
Lacquer thinner will remove it from most materials.
Lacquer thinner.
Use heated lacquer remover.
It depends on the type of paint. Lacquer thinner will remove most oil based and latex paints from a paint sprayer, however, spray gun cleaner will remove it better.
Unfortunately, as far as I know, there isn't really a way to stop this. The best way to help prevent this is to be very careful with your sax, but it's virtually impossible to keep those pestering little scratches off your lacquer.
Use lacquer thinner on a rough rag. If necessary remove hardware from the door.
form_title= Oriental Lacquer form_header= Keep your home beautiful with oriental lacquer. How much lacquer do you need?*= _ [50] Where will you be using the lacquer?*= _ [50] What is your budget for lacquer?*= _ [50]
We were attempting to remove lacquer from a quarry tile floor. We had inadvertantly put lacquer on quarry tile, which I guess is a no-no. We had a white discoloration that was appearing after only a few days after application. This discoloration was determined to be lacquer that was not bonding properly, and the problem was growing. The only way to correct this problem was to completely remove the lacquer. We sought help through this help sight, but got no answers, so we experimented on our own. We reasoned that lacquer thinner should thin lacquer, so maybe it would remove it. We tried a test area, and it did remove it, but not completely. We deduced that we were only thinning it, and when it dried, there was still just a thinner layer on the quarry tile. So we went to a more powerful thinner- acetone. Acetone has a quicker evaporation rate than lacquer thinner. We used absorbent rags and wiped on the acetone and off with the lacquer ! We had to repeat the process several times with clean rags each time, to get it totally clean. Our rags turned yellow after they dried, indicating to us that we were getting the lacquer finish removed. Keep in mind that we used lots of precautions- cannister-style breathing apparatus, rubber gloves, non-absorbent knee pads, lots of ventilation, etc., etc. We made sure all heaters, etc. were turned off so not to ignite any fumes. DO NOT attempt to take off any lacquer without at least the above protection, if not more !
No, the solvents in lacquer are to hot and volatile. The lacquer will cause bubbling of the acrylic paint.
You'll need to use some lacquer thinner and a wire brush to remove any varnish on brick.
Lacquer thinner will remove it, then the stainless should be wiped completely dry of any residue.