on the turn signal there is a verticle swivel button which dims the interior guages at night. Move that switch past it's end point (toward the front of the car) 1 click and all the dome lights are illuminated.
Point of interest = adjust that same switch all the way down, and your interior lights will NOT come on when exiting the car at night (very handy when the kids are asleep and you need to fill up)
A scan tool is required to read the trouble codes.
Yes
There wasn't a 2015 Chrysler Pacifica. In 2015 there was a Chrysler Town and Country. It's spare , if equipped, is located under the van below the front row seats. Most did not come with a spare tire.
after having car diagnosed by a Chrysler mechanic for $70 I was told that the light was on because the car needed the EGR valve for $406.00
chanching rotors on a pacifica is simple pull out the cotter pin in the middle and the rotor should come right off
Stop! Theres three lugnuts holding that on. Take all the lugnuts off first and it will come right off.
I'm having the same problem and from what I understand we are not the only ones. There is a problem with the ABS sensor in the wheels and it is a widespread issue with most Pacifica owners. If you fix this problem, you still may have issues with the other side. Repair cost ranges from $350 to $500. Good luck.
No
Disconnect the car's battery for 10 minutes. If a problem does exist, the light will come back on within 75 miles or so.
The Chrysler Cirrus did not come out until 1995. You reset the check engine light with a scan tool or by unhooking the battery. If you have not repaired the cause of the code the light will come back on.
The computer detected a malfunction that went away. A code should be stored in the computer that will give a record of what the malfunction was.
Check the wiring for the oil sensor. It is located by the oil filter, and could have been pulled loos during the change.