0
Why did your oil light come on after oil changed in 2005 Chrysler 300?
Wiki User
∙ 9y ago
Check the wiring for the oil sensor. It is located by the oil filter, and could have been pulled loos during the change.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
Why does the OBD light come on in the 2005 Chrysler 300?
after having car diagnosed by a Chrysler mechanic for $70 I was told that the light was on because the car needed the EGR valve for $406.00
How do you check what's causing your engine light to come on in your 2005 Chrysler Pacifica?
A scan tool is required to read the trouble codes.
Is it common for the oil light to come on on a Chrysler voyager?
No
How do you reset check engine light on a 2005 Chrysler sebring sedan?
Disconnect the car's battery for 10 minutes. If a problem does exist, the light will come back on within 75 miles or so.
What is the value of an autographed muhamad ali photograph with Elvis?
i changed the running light bulbs (3 of 4 are out) on Chevy 2005 trailblazer, and they still don't come light up?
How do you reset the check engine light on a 1994 Chrysler Cirrus?
The Chrysler Cirrus did not come out until 1995. You reset the check engine light with a scan tool or by unhooking the battery. If you have not repaired the cause of the code the light will come back on.
Why would your check engine light come on after you had your torque converter changed in your 1999 300m Chrysler?
Something may not have been plugged in, have the system checked for codes to know possible causes.
Why did the check engine light come on then go off on a 2005 Chrysler 300?
The computer detected a malfunction that went away. A code should be stored in the computer that will give a record of what the malfunction was.
Why would oil light come on in your 1999 Chrysler Intrepid even after you have had the oil changed?
Oil pressure sensor failure, wrong oil, low oil level, internal engine failure.
How do you change rear brake light 2000 Chrysler Concorde?
Brake light, on your 2000 Chrysler Concorde, by accessing it from the inside of the trunk. Take hold of the brake light, push in and turn. The brake light will come out.
How do you replace a map light bulb in a Chrysler 300m?
You can replace the map light bald, on your Chrysler 300, by removing the decorative retaining nut. The lens will come off with the nut, exposing the light bulb.
Why does the battery light come on for a 2000 Chrysler Sebring JXI?
There is a charging system malfunction.
