answersLogoWhite
Headlights Tail and Brake Lights
Nissan Pathfinder
Ford Expedition XLT

How do you get the grill off to replace headlights on a 1992 Pathfinder?

151617

Top Answer
User Avatar
Wiki User
2006-05-29 21:39:47
2006-05-29 21:39:47

There are some captive fasteners on the grill itself. Use a 1/4" slotted screwdriver to release them. Only turn them about a quarter turn to release them while gently tugging on grill. Be careful handling the grill. The support brackets molded on it are fragile.

1

Related Questions

User Avatar

how to adjust headlights on 1992 silverado

User Avatar

Unscrew the trim piece around the headlights, be careful as to not lose this. Pull the light out, unplug, replace. Simple as that

User Avatar

The factory sizes for the 1992 Pathfinder are: 235/75-15and 31X10.5-15 (optional tire).

User Avatar

pop the hood and unscrew the plastic caps that hold the bulbs and and replace with new bulbs

User Avatar

Yes, the 1992 Nissan Pathfinder V6 is an interference engine. Cam belt must be replaced every 60,000 miles.

User Avatar

BD's Mongolian Grill was created in 1992.

User Avatar

The starter relay on a 1992 Pathfinder is mounted between the transmission and engine block. The starter uses a gear drive to crank the engine and help it start.

User Avatar

Do you have sealed beam headlight? If so, Remove the grill if necessary. Remove the headlight retaining screws These are the three or four short screws. Do not touch the 2 longer aiming scews.Remove the headlight ring and pull the bulb out. Put the new one in so the the word top is on top. Replace the ring and the grill and test Good luck

User Avatar

Disconnect the battery, loosen tensoiner, " the top middle wheel, under distributor cap" disconnect the wires on the alternator , unbolt and good to go

User Avatar

I just did the same on my 94. You have to remove the clips that hold in the grille, then lift and pull out the grille. This gives you access to the headlight. There are four small screws on the trim around the headlight that hold the light in place. Be careful with the screws, they are very easy to drop and lose. Then, you can simply unplug the light, pull it out and replace it. I also have a 94 and would add that the four grill clips are on top of the grill. After un-fastening them, pull up on the grill to get it off of the truck. Also as a tip, put the fastening clips back into the grill, first, instead of in the frame. That way, all you have to do is pop the grill (with fastening clips in place) back onto the body. I have changed the headlights on my 1994 pickup 3 times now. But I never had the marvellous idea to place the clips in the grille first, not the frame. Thank you...that`s good advice.

User Avatar

should be fine, they share the same body style: http://en.wikipedia.org/wiki/Cadillac_Eldorado#1992.E2.80.932002

User Avatar

There are 4 clips holding the headlights in place remove them and it will come right out a flat tip screw driver will get them out with out braking them.

User Avatar

How do you replace the clock on accord 1992

User Avatar

How do you replace evaporator on a 1992 ford explorer?"

User Avatar

First pop your hood. After you raise the hood, and your looking at the front headlights. Directly above the headlights. In each corner of the headlight is a screw. remove that screw and pull the signal light right out. turn it over to replace old bulb. Once your done reinstall turn signal. Then tighten screw back!

User Avatar

I don't know if this will answer your question but I did have a buddy, whos dad took the top headlights out of an older gmc pickup truck, they had like rectangle headlights and the plastic housing too. he did that so he could get the BLU color headlights in. I don't know how he got them to fit and im not aware of the modifications to do so but that's all I know and I hope it helps you.

User Avatar

If the headlights will not work properly on a 1992 Honda Accord than the fuse may be burnt out. To check the fuse locate it under the hood of the vehicle. The fuse box is behind the battery.

User Avatar

how do you replace a CV joint on a 1992 Chevy pickup?

User Avatar

1992-1996 Toyota Camry headlight adjustmthere are two screws which affect the headlight alignment. The one that faces up on nearest the fender is the verticle adjuster.The one that is one the side next to the grill is the horizontal adjuster.

User Avatar

how do you replace ignition switch on a 1992 Chevy cavalier 2.2 4 cylinder

User Avatar

how to replace a serpentine belt on 1992 grand am 2.3l

User Avatar

Headlights have to be adjusted by a licensed facility because it is a state regulated thing. Check in the phone book for professionals that are licensed to do so.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.