For a 2 door 2005 Accord Remove the 3 nuts on the studs on the tail light assembly Remove the wheel on the appropriate side of the car Remove the 3 screws that hold on the rock guard / mud flap Remove the 1 screw at the end of the bumper cover ( just above the aforementioned rock guard ) The screw head will be facing the ground Removed the 2 clips on the underneath side of the car at the back, each about a foot from the center of the car, by prying the head with a flat blade screwdriver With the trunk lid open, locate the 2 covers along the lower part of the opening and pry loose ( the covers are about 1" X 1.5" ) With a 10mm socket, remove the 2 bolts and gently pull back the bumper cover The 2 #@%&* screws that have held the tail light assembly are on the underneath side of the tail light assembly. HINT: remove the 2 nuts on the bracket instead. This will make removing and reinstalling the screws much easier I have the same question I need to replace my 2005 lenses, I removed the three bolts but I still can't get them off???????
Yes, replace the head bolts.
14mm
The tail lights on a 2006 Honda Civic are mounted to the brackets in the trunk of the car. Open the trunk and remove the mounting bolts. Unplug the bulbs and the housings will then be able to be removed.
Turn counterclockwise to remove them.
It is hard to find. Look where the engine bolts to the transmission.
next to the oil filter, you will need to remove your intake box from the back of the manifold to get to it. there are two bolts that will need to be removed. easy 30 minute job
According to the 1994-1997 Honda Accord Service Manual the torque specs are: 74 N.m (7.5 kgf.m. 54 Ibf.ft)
To remove a stock stereo from a 2005 Honda Civic LX all the mounting bolts need to be off. The center console will have all the necessary screws removed to reach the mounting bolts. When all the bolts are removed the radio unit will slide out.
first remove the bumper turn lights...two screws on one each light..then remove the lights carefully, so you do not break them.... After that...remove the bumper screws in the wheel wells.... Then, where you have removed the bumper lights...with a socket extension..and a 12 mm socket...remove two bolts on each bumper mounts.....then the bumper should come off in a forward direction.... you now have access to both headlight assemblys.
"Under the passenger side dashboard.Closest to the door.Unhook the power wire,three bolts and its off."
Look inside the trunk under the light for bolts to remove the light.
here you go 22 lb first then 49 lb pounds