Remove the two rubber grommets on the inside and, with a flat-blade screwdriver, flick the spring steel catches inside, so that the light unit pops out of its seat, exposing the 18Watt wedge fitting bulb.
Adjust the brake switch which is above the brake pedal.
On the top of the back window position in the middle .
You normally gain access to the bulb from inside the trunk.
Stop light. Third brake light, or center high mounted stop light (CHMSL).
did you figure out how to? mine has the same problem
first remove wheel and then the brake caliper remove the centre cap in middle of break disc your disc should come off at this point reverse order to put back.
make a slushi gun and shoot it at a window
you get a hard football a smash it at window good luck
DOT 4 is sufficient
microfiber fluid
Dot 3
If you mean the high mount brake light either in the back window or above the tailgate, then yes. They all work simultaneously. If one is out, check the bulbs.