0
How do you get to the power antenna on a c5 to remove it and put in a new one?
Wiki User
∙ 14y ago
Remove the right most tail light. Two screws hold the light in place. The antenna is directly behind the light.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you replace a 1994 Honda Prelude antenna?
You would need to get a tool to remove the notched chrome piece that holds the antenna mast, or carefully use pliers to unscrew it out. After you remove that, the antenna itself is held by a 10mm bolt. to get to it you'll need to open up the trunk lining near the antenna location and remove that bolt. Then, pull the antenna far enough to disconnect the antenna wire and power. Assuming the antenna motor is still functional, you can then replace the antenna mast with a new one. Or, you can install an aftermarket rubber antenna.
How do you replace an antenna on a 1997 Lumina?
If the antenna is broken off at the base the entire base will need to be replaced. In order to do this the upper dash pad and the cowl will have to be removed so the three bolts will be exposed to remove the broken one.
How do you remove the antenna mount in order to remove the fender on a 2000 dodge neon?
Remove mast. Inside car (pass. site): disconnect antenna cable,(you may have to remove door-sill and kick panel) Outside: remove tire (makes it easier to) remove inner splash shield, remove mounting screws and pull antenna base and cable from under fender. Note:there is a rubber grommet going into the car and it may be hard to remove, this is not a big deal if you are replacing it with a new one. (part of a new antenna)
How do you remove the power antenna motor on a Mercedes 500 sl?
Its best to remove everything from the trunk! The driver's side remove the [6 CD] changer from its metal support by removing the two Phillip's shrew's. Remove the CD changer support bracket [2. 8mm] bolts then remove the clips from the trunk lining and remove the trunk lining. You will now see the antenna motor assembly. Unscrew the top of the antenna from the rear fender [13 mm spanner]. there is one 10 mm shrew holding the antenna onto the metal chassis of the trunk. Remove the evaporation system charcoal canister from the wheel well by pulling it [up] to remove it from the clips. this must be done to create clearance to remove the antenna unit. Then remove the antenna cable from the antenna unit.
How do you replace a broken antenna on a 1993 Isuzu Trooper?
I did this on a "96" Trooper for a power antenna. Remove the lining in the wheel well above the tire. You should be able to find any replacement screws or clips in your local auto parts store for reinstalling, if needed. You will need to turn your tire all the way to one side for better access of some screws and the antenna itself. There will probably be a couple of screws holding the power antenna unit to the fender. Remove the screws anchoring the power unit. At this time, you probably want to disconnect your car battery. When you open the power unit to reveal the inner workings, the power winder can automatically activate. There will be no way to stop it without disconnecting the battery. You will want to examine how the power unit is wound and copy it with the new antenna. Good luck.
How do you get to the power antenna on a Lexus rx 300?
Just remove the nut on the outside, turn your radio on (to initiate antenna rising) and pull out the antenna as it is pushed out. Inspect the plastic cable for damage (if it is broken then there are going to be pieces left in the motor, in this case you will have to remove it from the trunk and open it up to remove the pieces). If it is just the worn out teeth as expected, replace it by inserting the cable of the new one with teeth facing forward until it stops, then turn off the radio and the motor will pull in the antenna. Quick fix should take you no longer than five minutes. Good luck.
How can you send your own tv signals through antena locally?
Yes, but it is illegal. You would need a power amplifier and remove the transformer from the antenna if it has one.
How do you replace a broken automatic antenna on a 94 Honda Accord with a fixed antenna?
That's easy, I did the same job to my 90 accord. First buy a fixed antenna, I went to radio shack, something like $12, instead of $200+ for the power antenna from Honda.. In the trunk, on the side of the antenna, pull back the trunk liner but be careful not to break an clips. once the trunk liner is out of the way, you'll see what tools you'll need, and what nuts to turn. The new antenna will have all of the parts you need, find one that fits the fender the best. It is a relatively easy job, self explanitory once you expose the antenna from under the trunk. I completely took the old power antenna assembly out of mine. It's pretty self explanatory. Remove old antenna assembly, install new fixed antenna to quarter panel, plug in your antenna cable, replace trunk liner (carpet).
Change a radio antenna 98 Ford Escort?
The radio antenna is a fine wire imbedded in the windshield. If your radio doesn't pull in any stations, but you get static then probably the cable came out of the back of the radio. If you recently got a new windshied it may have not had the antenna. You should be an antenna at an auto parts store and install it on the front fender.
Which power antanna was used on a 1989 Cutlass Supreme?
Check your RPO codes. If it has an U75 than it had a power antenna. If it has RPO code US6 it has a painted fixed antenna. There was only one style power antenna used from the factory.
The power of the signal would be high or low if you are transmitting in omnidirection antenna as compared to directional antenna?
The power of the signal, as perceived by the receiver, will be lower with an omnidirectional antenna. This is because the omnidirectional antenna is transmitting in all directions, while the directional antenna is transmitting in only one direction.Think of the directional antenna as a lens, focusing proportionally more power in a smaller space.
How do you replace the radio antenna on a 2003 Elantra?
You can get a new mast for the antenna from any Hyundai dealer. This happens a lot and they usually stock them. If you can get all of the old mast out, it's a rather simple procedure, although it can be tricky to get the antenna to grab the new mast. 1. Remove the nut holding the mast into the antenna (12mm I think). 2. Turn the radio on and pull the antenna mast out. There should be a round disc and a ball on the bottom. If not, you'll need to remove the antenna assembly and take the rest of the pieces out of the antenna. If the disc and ball are present, continue with step 3. 3. Push the plastic of the new antenna mast down into the antenna as far as possible. 4. Have an assistant turn off the radio while you're pushing the plastic into the antenna. 5. If the antenna does not grab onto the mast, return to step 2. Otherwise, continue with step 6. 6. Install and tighten the mast nut. 7. Turn the radio on. 8. Turn the radio off. Your mast should now be properly seated. 9.there is a plastic washer also inside that you will have to force the mast thru to get it the set in the motor ! if you cann't push thru , next step take out motor and remove the tube for antenna, you find in sitting inside make sure connect it back the same it is stting , after that replace in car, have someone turn and off radio,job done
