Open up the trunk lid, find the Phillips screws above the tail lights and the whole tail light bucket will pull out as one piece. Light sockets are behind.
First check the brake light fuse, if good, then test the brake light switch.
check all brake bulbs a filiment may have shorted out
Check the brake light switch on the brake pedal. Might have to replace it.
In the 1993 Chevy Caprice there is a brake sender located inside the steering column where the brake pedal is attached. Perhaps the brake lights are not working because of this, when a person hits the brakes. There could also be a fuse blown or a broken or shorted wire.
its related the the abs system. (anti lock brakes) its an ebcm, electronic brake control module.
Yes they indeed have brake lights...
AnswerLook under the kick panel driver's side. Should be to the above left of the brake pedal.For 1991 and up Caprice, open the driver's door and remove the cover from the side of the dashboard.
You will need to remove the tire and wheel from your 1992 Chevrolet Caprice Classic. Remove the brake shoe spring and caliper. The brake shoes will come off. Reverse the process to install the new brake shoes.
Possibly defective or misadjusted brake light switch.
the rotors are front mounted brake (pads) and the rear are usually the spring type ..also known as(shoes)
brake light plunger switch on the brake pedal maybe faulty, remove it and connect the two wires together and pull apart and see if lights go on and off
brake line has air...