How do you get xbox 360 to recognize Wii sensor bar?

Answer 1

How to fix a wii sensor bar is quite a vague question...the answer depends on what its wrong with the bar...is it the wires? is it the plug? is it the bar itself? please be more precise so i can help u with this...

===

The Wii Sensor Bar's wire is near impossible to repair. Even attempts to splice and reattach the wire has failed. The easiest thing to do would be to purchase a new sensor bar. They cost only $6.95 at the following website which is in the USA:

http://store.richspsxparts.com/wiisebarwiwi.html

Answer 2

Just plug the end of the sensor bar's cord into the small, orange-rimmed socket at the back of the Wii. Then set the sensor bar in the middle of the television, whether on the top or bottom. You should also stick the sensor bar to the surface it's on, whether with tape or the included adhesive pads. For more information, you can check the sensor bar settings in the Wii Settings Menu, and also check the page below.

Answer 3

If a Wii Remote is not responding properly, the steps suggested by Nintendo Support are:

• Make sure there is nothing obstructing the Wii Remote sensor.

• Try replacing the batteries in the Wii Remote.

• Reset the remote by removing the batteries for a minute, reinserting them and waiting a few seconds, then resynchronizing the remote to the Wii.

• Make sure the Wii Remote is sensing direction correctly by holding it button-side-down and lightly tapping the side of the remote.

• Change the sensitivity settings in the Wii options menu.

If none of the above correct the problem, contact Nintendo at 1-800-255-3700 (+44 (0)870 6060247 in the UK) for assistance.

Answer 4

Usually the problem is that it is just in a bad spot and is too far away to pick up the movement of the remote. Try putting in on top of the tv or very close to the tv. I found this helped a lot for me. If not, it might be faulty or something.

Answer 5

if it didnt work from the beggining, return it. If it stopped working, buy a new one...

Answer 6

Look in the Wii Manual. pshaw!!! plug in the cord to the second to lowest hole in the back of your wii

Answer 7

You know its broke by pointing the wii remote at it and you cant see the arrows your wii remote makes.

Answer 8

top of the tv