Well, have to click the botton to unlock it
To fix a Toyota Sienna driver's side seat belt that is stuck, you might need to pull the entire belt out slowly until it is completely extended. Then, allow the belt to retract slowly.
Buckle your seat belt, works every time.
your joking right ?
To remove the driver side seat belt, first, ensure the vehicle is parked and the engine is off. Locate the seat belt retractor, usually mounted on the side of the seat or the floor. Use a suitable tool, often a socket wrench, to remove the bolts securing the retractor and the buckle to the vehicle. Once the bolts are removed, gently pull the seat belt out to detach it completely.
Yes
Yes it does: Driver & Passenger front seat belt sets are mechanically different & have separate part numbers.....
Press the red button at the side of the seat. You can then open the door and leave the car.
the receiver for the belt has a sensor. if it fails the light will continue to flash even though the belt is buckled. replace it!
replave retractor
Check the connection at the floor behind the seat to see if it is disconnected.
No it is not statistics show that of all crashes into the drivers side of the car, the said driver has a 28% chance of surviving with a seat belt and 82% of living without one.
To replace the driver side pushbutton seat belt buckle on a 1997 Toyota Previa, first, remove the plastic cover around the seat belt assembly by unscrewing any screws or clips. Disconnect the seat belt buckle from its mounting point by unbolting it and unplugging the electrical connector if equipped. Install the new buckle by reversing the removal steps, securing it firmly and ensuring the belt operates correctly. Finally, replace the plastic cover and test the seat belt functionality.