answersLogoWhite

0

What else can I help you with?

Related Questions

How do you take a driver seat out of an impala?

On newer models, you have to move the seat all the way forward, remove side trim cover, remove seat belt anchor bolt, remove seat rails retaining bolts, tilt seat upward, disconnect wires, remove seat...


How do I fix a Toyota Sienna driver's side seat belt that is stuck?

To fix a Toyota Sienna driver's side seat belt that is stuck, you might need to pull the entire belt out slowly until it is completely extended. Then, allow the belt to retract slowly.


How do you disable the seat belt alarm for the driver's side on a 2008 GMC Sierra?

Buckle your seat belt, works every time.


How do you remove the driver's seat on a 2007 suzuki 800c intruder?

To remove the driver's seat on a 2007 Suzuki 800c Intruder you need to remove the headrest and remove the screws. Next, remove the bolts and washer on each side of the front of the driver seat.


How do you replace the driver side pushbutton seat belt buckle on a 1997 Toyota Previa?

To replace the driver side pushbutton seat belt buckle on a 1997 Toyota Previa, first, remove the plastic cover around the seat belt assembly by unscrewing any screws or clips. Disconnect the seat belt buckle from its mounting point by unbolting it and unplugging the electrical connector if equipped. Install the new buckle by reversing the removal steps, securing it firmly and ensuring the belt operates correctly. Finally, replace the plastic cover and test the seat belt functionality.


Is there a switch in the driver side seat belt that affects the air bag?

Yes


How do you get your driver side seat belt to unlock?

Well, have to click the botton to unlock it


To buy a replacement seat belt for a 1997 Subaru Outback Legacy Does it make a difference if the seat belt is specified as a left side or right side belt?

Yes it does: Driver & Passenger front seat belt sets are mechanically different & have separate part numbers.....


How do you access the fuel pump?

Depending upon what year, it is typically under the rear seat on the driver's side. You should disconnect the negative terminal on the battery first and then remove the seat cushion bottom from the driver's side rear seat. Depending upon what year, it is typically under the rear seat on the driver's side. You should disconnect the negative terminal on the battery first and then remove the seat cushion bottom from the driver's side rear seat.


How do you fix a driver side seat belt light that blinks even when you are wearing your seat belt?

the receiver for the belt has a sensor. if it fails the light will continue to flash even though the belt is buckled. replace it!


How can you fix a front driver's side seat belt that will not retract on your 91 lumina?

replave retractor


How do you remove the seatbeltS on a aztek?

Front seats: Driver side belt is bolted to the floor under the the drivers seat. Rear left bolt or rear bolt closest to door. Pass side is bolt same way, but the bot is on right, closest to door. Both drive and pass side have plastic pillars that pop-off, which hold the bolt that secures the other side of the belt. Rear seats: Pull the handle next to the seat, between seat and door. This will allow you to drop the seat forward, the other lever on the same side will allow you to lift the back of the seat up. Remove the seat by pulling the bar under the seats. Belt is secured to the seat itself.